25 December 2024 in IEEE Transactions on Instrumentation and Measurement
A femtosecond laser micromachining technique is used to write optical waveguides directly into the two sides of a three-core fiber from a single-mode fiber. The intermediate fiber core is welded and aligned, with an optical waveguide length of 1420μm and an angle of 1.15°. This method realizes parallel writing technology for multi-core fibers, achieving a fiber Bragg grating (FBG) signal-to-noise ratio (SNR) of 20dB. The temperature and strain characteristics of the sensor are studied. Through experiments, the average temperature sensitivity is found to be 11.3pm/°C, and the strain sensitivity is 1.69pm/με. The sensor exhibits good temperature and strain response characteristics and stability. This method provides a novel approach to parallel writing in multi-core fibers and lays a foundation for subsequent experiments involving curvature and torsion characteristics. It holds great potential for applications in ocean temperature and depth measurement.
23 February 2026 in IEEE Transactions on Instrumentation and Measurement
To address the growing demands for high-precision pose monitoring and health diagnostics in industrial and medical robotic arms, this paper proposes an integrated wavelength division multiplexing multi-core optical fiber detection system. A triple-core fiber serves as the sensing element for simultaneous strain, bending, and torsion monitoring. Efficient optical waveguides and fiber Bragg grating arrays are fabricated using femtosecond laser micromachining, creating wavelength-decoupled multi-parameter sensing units. Experimental results demonstrate excellent strain sensitivity is 1.78-1.91 pm/με and discrimination in strain tests; significant multi-parameter decoupling and directional identification capabilities in bending/torsion tests; and bending sensitivity enhanced to ±199.2 pm/m-1 through differential calculation. The measurements are supported by systematic uncertainty analysis, indicating combined standard uncertainties of approximately ±2.5 με, ±0.15 m-1, and ±0.8° for strain, bending, and torsion, respectively. This system exhibits extremely high repeatability and stability. Its wavelength drift is less than 0.04 nm, and the intensity fluctuation is less than 0.04 dB. At the same time, it can also achieve distributed multi-point sensing along the robotic arm. Overall, the proposed sensor provides a high-precision and reliable multi-dimensional sensing solution, showing broad application potential in intelligent manufacturing and minimally invasive medicine.
1 August 2026 in IEEE Sensors Journal