1 January 2020 in IEEE Transactions on Applied Superconductivity
Electric machines with very high power-to-weight ratios are inevitable for hybrid-electric aircraft applications. One potential technology that is very promising to achieve the required power-to-weight ratio for short-range aircraft, are superconductors used for high current densities in the stator or high magnetic fields in the rotor. In this work, an in-depth analysis of potential fully and partially superconducting machines is performed, taking into account all relevant physical domains such as electromagnetics, superconducting properties, thermal behavior as well as structural mechanics. For the requirements of the motors in the NASA N3-X concept aircraft, we find that fully superconducting machines could achieve 3.5 times higher power-to-weight ratio than partially superconducting machines. Furthermore, the model can be used to calculate the relevant key performance indicators such as mass, efficiency and cryogenic cooling requirements for any other machine design.
2 December 2024 in IEEE Transactions on Applied Superconductivity
As part of the German SupraGenSys project, a fully superconducting generator for wind energy conversion systems was investigated, which will be built and demonstrated as part of SupraGenSys 2. Therefore, this paper summarizes the main challenges and outlines the design strategy to achieve a design with low investment cost and high efficiency. The field winding and the armature winding consist of HTS tapes. The armature winding in particular has high alternating current losses due to the alternating magnetic field. These alternating current losses heat up the coils and must be compensated for by the cryocooler with high energy consumption. A highly efficient generator design can therefore still lead to a low overall efficiency of the system. Or a design with low AC losses can be achieved by using a large amount of HTS tapes, which increases the investment cost of the system significantly. In this paper, design strategies are published to achieve a generator design with low AC losses by identifying the factors that influences of AC losses and developing methods to reduce the losses. For this purpose, the tangential component of the flux density is investigated and the AC losses are determined using the TA formulation [Kim et al. (1962)]. Compared to the methods published in [2], this work focuses more on the overall design of the generator and its stator and rotor windings. The design is iron-based, which allows the use of the iron geometry to influence the AC losses and protect the stator winding from the rotor field. As a result, the AC losses are dominated by the intrinsic field of the coils, which can be influenced by the coil geometry. This enables a design with very low AC losses, high efficiency and modest use of HTS tapes.
9 March 2026 in IEEE Transactions on Applied Superconductivity
In the SupraGenSys 2 project, a 250 kW fully superconducting demonstrator for a wind energy generator is being designed and constructed. This demonstrator will be set up under laboratory conditions and will serve as a platform for investigating a fully superconducting 10 MW wind energy system. In addition to the well-known challenges of superconducting windings, such as AC losses, this design must also address various other design aspects, including highly saturated iron and the impact of cooling lines. This work provides an overview of the calculation results obtained so far and offers insights into the challenges associated with a low–AC-loss winding design.