This article employs the method of electrochemical impedance spectroscopy (EIS) to extend the physics-based, nonlinear equivalent circuit models of supercapacitors (SCs) to describe lithium-ion batteries (Li-ion). The following section briefly introduces the method of electrochemical impedance spectroscopy and presents measured impedance spectra. From these spectra, appropriate equivalent-circuit models are deduced. After this, the MATLAB/Simulink implementation of the new simulation models is discussed, and simulation results, as well as verification measurements, are provided. Finally, conclusions are drawn, and future perspectives of the new impedance-based modeling approach are outlined.
Including a certain amount of carbon in the negative active material is currently the state‐of‐the‐art method to improve the dynamic charge acceptance (DCA) of lead–acid batteries. The DCA is a key parameter of batteries used in microhybrid cars where brake energy recuperation is implemented. To find the optimal carbon additive, it is essential to test the carbon both in short‐term and long‐term tests. This work investigates the long‐term and short‐term DCA of 2 V, 2.5 Ah lead–acid cells and correlates the results with the external surface area of the carbon. Five different carbons with tailored particle size (27–633 nm) and external surface area (7.1–159.3 m2 g−1) are employed as additives in the negative electrodes. The charge acceptance of cells according to the charge acceptance test 2 (SBA), the DCA (EN) test, and the run‐in DCA test (Ford) is increased via an increase in the carbon external surface area. A correlation between the short‐term tests and the first week of the run‐in DCA test is established for the carbon impact. After several weeks of run‐in DCA test, the carbon effect is diminished and only a differentiation between high and low DCA cells is possible.