25 March 2015 in Nano Letters
1 March 2018 in Journal of Renewable and Sustainable Energy
In this study, the snow melting behavior of several photovoltaic technologies, all installed at the same location under identical conditions, is analyzed based on the time-dependent changes of the snow cover, which is extracted from images of a monitoring webcam, for various temperature and irradiation conditions. From this study, conclusions can be drawn for the optimum module technology for a given location with respect to snow-dependent yield losses. In particular, the melting behavior is analyzed regarding its dependence on the ambient temperature and the irradiation level. Finally, the relevance of snow cover-related losses is discussed. The study shows that comparably large frameless modules exhibit the highest snow shedding rates. Hence, they are snow-free for longer periods, thereby increasing their potential for electricity generation in snowy regions. In summary, this paper reveals the beneficial snow removal properties of large frameless modules for snowy areas by applying a novel image processing technique for the determination of the snow-covered area fraction of the modules.
1 March 2018 in Journal of Renewable and Sustainable Energy
In this paper, the influence of pre-existing crystalline damage, such as cracked or broken cells or soldering failures, as they are frequently observed in operating photovoltaic (PV) plants, on the degradation behavior of mono- and polycrystalline silicon PV modules is investigated. In particular, it is analyzed if and to what extent pre-damage introduced prior to lamination propagates upon stress exposure. Therefore, the pre-damaged modules are exposed to various accelerated aging conditions in order to analyze the impact of the pre-damage on the degradation behavior under the respective aging scenario. In order to separate the influence of the pre-damage from composition-induced influences, the choice of materials used in the modules is varied. These investigations reveal that none of the accelerated aging tests causes any change in the pre-existing damage. In fact, the degradation behavior and rate rather depended on the choice of the module components than on the nature of the pre-damage. Finally, these results are compared with indoor and outdoor results obtained from other studies.
10 August 2017 in Progress in Photovoltaics: Research and Applications
1 August 2019 in Solar Energy
27 June 2019 in Zeitschrift für Naturforschung A
With the spread of photovoltaics (PV) and increasing diversity in PV panel technology, quantitative comparison of the modules is highly desirable for consistent on-site quality assessment. Electroluminescence imaging reveals many defects, such as macroscopic crystal or electrical contact defects, but quantitative comparison outside the laboratory without controlled environment is still difficult, especially for different detector technologies. Here, we show how this problem can be addressed by adding reference spots in the module area: One passive dark spot and an active bright spot composed of a high-power back-contacted silicon PV cell. Those reference spots are used to evaluate the module’s electroluminescence signal under different environmental conditions and to establish comparable results. Additionally, the comparison of images acquired with different camera technology detectors, such as silicon and InGaAs, is realised for signal levels.