6 December 2013 in Science
Deep Drilling for Earthquake Clues: The 2011 M w 9.0 Tohoku-Oki earthquake and tsunami were remarkable in many regards, including the rupturing of shallow trench sediments with huge associated slip (see the Perspective by Wang and Kinoshita ). The Japan Trench Fast Drilling Project rapid response drilling expedition sought to sample and monitor the fault zone directly through a series of boreholes.
Chester
et al.
(p. 1208 ) describe the structure and composition of the thin fault zone, which is predominately comprised of weak clay-rich sediments. Using these same fault-zone materials,
Ujiie
et al.
(p. 1211 ) performed high-velocity frictional experiments to determine the physical controls on the large slip that occurred during the earthquake. Finally,
Fulton
et al.
(p. 1214 ) measured in situ temperature anomalies across the fault zone for 9 months, establishing a baseline for frictional resistance and stress during and following the earthquake.
1 September 2013 in Geology
The thickness of an active plate boundary fault is an important parameter for understanding the strength and spatial heterogeneity of fault behavior. We have compiled direct measurements of the thickness of subduction thrust faults from active and ancient examples observed by ocean drilling and field studies in accretionary wedges. We describe a general geometric model for subduction thrust décollements, which includes multiple simultaneously active, anastomosing fault strands tens of meters thick. The total thickness encompassing all simultaneously active strands increases to ∼100–350 m at ∼1–2 km below seafloor, and this thickness is maintained down to a depth of ∼15 km. Thin sharp faults representing earthquake slip surfaces or other discrete slip events are found within and along the edges of the tens-of-meters-thick fault strands. Although flattening, primary inherited chaotic fabrics, and fault migration through subducting sediments or the frontal prism may build mélange sections that are much thicker (to several kilometers), this thickness does not describe the active fault at any depth. These observations suggest that models should treat the subduction thrust plate boundary fault as <1–20 cm thick during earthquakes, with a concentration of postseismic and interseismic creep in single to several strands 5–35 m thick, with lesser distributed interseismic deformation in stratally disrupted rocks surrounding the fault strands.
1 February 2008 in Nature
27 June 2010 in Nature Geoscience
1 October 2011 in Tectonophysics
10 February 2012 in Geochemistry, Geophysics, Geosystems
Convergent plate boundaries accommodate intraplate displacement within a ∼100–1000 m thick shear zone. Marine geophysicists typically define this zone, the subduction channel (SC), as the sedimentary layer between the downgoing oceanic crust and the base of the upper plate. Geologists and modelers, instead, perceive the SC as a specific type of shear zone. The original theory of SCs was developed when the net accretion of marine sediments to the forearc was thought to typify a convergent margin. While erosive margins were briefly mentioned, their mechanics were not discussed in any detail. We now realize that subduction erosion is taking place at roughly half of the modern subduction margins. Here we review and revise the theory of erosive SCs (1) to unify this concept across disciplines, focusing on the meaning of the channel's boundaries; (2) to redefine the portions of the forearc included in the SC concept; and (3) to better idealize this dynamic system where material supply to the channel, fluid content, and the heterogeneity of deformation all influence the SC's upper and lower boundaries. Migration of the channel boundaries controls the downdip variation of tectonic mechanisms that shape the margin. Within the shallow, <15 km deep part of the SC, a gradual change of physical properties defines three zones; zone 1 of rapid fluid dewatering, zone 2 of overpressure, and zone 3 with metamorphic fluid release. A SC is a dynamic feature with along‐strike and downdip variations caused by changes in channel material, in trapped fluid contents, and in interplate boundary geometry.