We investigate the atomic disorder effects on the half-metallicity of the full-Heusler alloy from first principles by using the Korringa-Kohn-Rostoker method with the coherent potential approximation. Our results show that disorder between Cr and Al does not significantly reduce the spin polarization of the parent alloy while disorder between Co and Cr makes a considerable reduction of the spin polarization. It is observed that the spin polarization of decreases with increasing Fe concentration x in both the ordered and the disordered structures, and that the effects of the disorder on the spin polarization is significant at low Fe concentrations. The results suggest that a highly spin-polarized ferromagnet with high Curie temperature will be obtained if a with the ordered structure can be fabricated at low Fe concentrations.
Gilbert damping for the epitaxial Heusler alloy films was investigated. Gilbert damping constant for the films was evaluated by analyzing the data of ferromagnetic resonance measured at the frequency of 2–20 GHz. Gilbert damping constant for the film without annealing was rather large, while it decreased remarkably with postannealing. Gilbert damping constant for the film annealed at was . These behavior of Gilbert damping constant can be well explained by the fact that the density of states calculated from first principles decreases with increasing the degree of order.
Fully epitaxial current-perpendicular-to-plane giant magnetoresistance (MR) devices with half-metallic (CMS) electrodes and a Ag spacer were fabricated to investigate the relationship between the chemical ordering in CMS and its MR properties, including bulk and interface spin-asymmetry coefficients and . CMS/Ag/CMS annealed at shows the largest MR ratio: 36.4% and 67.2% at RT and 110 K, respectively. An analysis based on Valet-Fert’s model reveals large spin asymmetry at the CMS/Ag interface, which contributes predominantly to the large MR ratio observed. First-principles ballistic conductance calculations for (001)-CMS/Ag/CMS predict a high majority-spin electron conductance, which could be the origin of the large observed in this study.
We have revealed the underlying mechanism of the martensitic phase transition (MPT) in a new class of ferromagnetic shape memory alloys, , by the combination of bulk-sensitive hard-x-ray photoelectron spectroscopy and a first-principles density-functional calculation. The Ni state in the cubic phase systematically shifts towards the Fermi energy with an increase in the number of Mn atoms substituted in the Sn sites. An abrupt decrease of the intensity of the Ni states upon MPT for has been observed in the vicinity of the Fermi level. The energy shift of the Ni minority-spin state in the cubic phase originates from hybridization with the antiferromagnetically coupled Mn in the Sn site. Below the MPT temperature, the Ni state splits into two levels located below and above the Fermi energy in order to achieve an energetically stable state.
Fully epitaxial Co2FexMn1−xSi(CFMS)/Ag/Co2FexMn1−xSi current-perpendicular-to-plane giant magnetoresistive devices with various Fe/Mn ratios x and top CFMS layer thicknesses tCFMS were prepared. The highest magnetoresistance (MR) ratios, 58% at room temperature and 184% at 30 K, were observed in the sample with x = 0.4 and tCFMS = 3 nm. Enhancement of interface spin-asymmetry was suggested for x = 0.4 compared with that at x = 0. A MR ratio of 58% was also observed even in a very thin trilayer structure, CFMS(4 nm)/Ag(3 nm)/CFMS(2 nm), which is promising for a next-generation magnetic read sensor for high-density hard disk drives.
We investigate and discuss the interaction of with graphene based on density functional (DFT) theory. We calculate the potential energy surfaces for the dissociative adsorption of on highly symmetric sites on graphene. Our calculation results show that reconstructions of the carbon atoms play an important role in the -graphene interactions. Activation barrier for dissociation on an unrelaxed graphene is considerably high, for a T–H–T geometry and for a T–B–T geometry. The T–H–T(T–B–T) geometry means that the center of mass position of is at the hollow(bridge) site, and the two H atoms are directed towards the top sites on the graphene. On the other hand, when the carbon atoms are allowed to relax, the activation barrier decreases, and becoming 3.3 eV for the T–H–T geometry and 3.9 eV for the T–B–T geometry. In this case, the two carbon atoms near the hydrogen atoms move towards the gas phase for the T–H–T geometry and for the T–B–T geometry.