Jiangsu Engineering Research Center of Novel Optical Fiber Technology and Communication Network, Suzhou Key Laboratory of Advanced Optical Communication Network Technology, the School of Electronic and Information Engineering, Soochow University, Suzhou, Jiangsu Province, China
Auto-generated profile, based on publicly available information
Lei Wang
Jiangsu Engineering Research Center of Novel Optical Fiber Technology and Communication Network, Suzhou Key Laboratory of Advanced Optical Communication Network Technology, the School of Electronic and Information Engineering, Soochow University, Suzhou, Jiangsu Province, China
Optical signal-to-noise ratio (OSNR) is an important parameter in coherent optical communication systems to monitor the quality of the received signal and the transmission-link fault. The OSNR monitoring technique based on the moments of the received signals is simply and blind, where no extra training sequence is required. The moments-based method works well with QPSK signals with constant modulus constellations but has degraded performance for 16-QAM and 64-QAM signals with multilevel constellations. Instead of calculating higher-order moments, we proposed an accurate second- and fourth-order moments-based OSNR monitoring scheme, where the clock recovery of the M-QAM signal is first implemented and then the inner amplitude level is extracted to estimate the OSNR values. The proposed method has been verified and evaluated in QPSK, 16-QAM and 64-QAM simulations and experiments.
We experimentally demonstrated a photoelectric nonlinear compensation scheme of optical phase conjugation (OPC) with complex-valued deep neural network (CVDNN) to mitigate fiber nonlinearity in wavelength division multiplexing (WDM) 64-QAM coherent optical transmission system. The factors to affect the performance of OPC and CVDNN are comprehensively considered. OPC in WDM system is experimentally optimized to alleviate the deployment requirements of strict symmetrical distributed power and chromatic dispersion. The performance penalty caused by the simplification of the OPC is further compensated by the CVDNN. The selections of the input neurons’ number and the optimization algorithm are also considered to design a simple two-hidden-layer-structure CVDNN. The proposed method is experimentally verified and evaluated in a 12.5-GBd 4-channel WDM 64-QAM 160-km standard single-mode fiber (SSMF) transmission system with channel spacing of 50-GHz. The experimental results show that the proposed nonlinear equalizer based on the OPC with CDVNN has a strong robustness to the input signal power and wavelength, which can not only improve the Q factor of the signal by 1.5-dB, but also greatly increase the total launched signal power.
The charge recombination at the TiO2 photoelectrode/electrolyte interface plays a crucial role in determining the efficiency of solid-state dye-sensitized solar cells (DSSCs) because of the poor interface contact at the TiO2 photoelectrode/electrolyte interface. In this work, we report the surface co-grafting of surfactants onto the surface of the TiO2 photoelectrode, and their effects on the photovoltaic performance of solid-state DSSCs. Three ionic surfactants, including anionic surfactants, sodium 2-ethylhexyl sulfosuccinate (AOT) and chenodeoxycholic acid (CDCA), and a cationic surfactant, dodecyltrimethylammonium bromide (DTAB), were applied for the modification of the TiO2 photoelectrode/electrolyte interface. The results show that co-grafting of surfactants AOT or CDCA on the TiO2 photoelectrode surface, and post heat treatment (above the melting point of solid-state electrolytes) could drastically improve the interfacial contact properties of the TiO2 photoelectrode/electrolyte interface, increase the penetration of the electrolytes into the porous TiO2 photoelectrode, and thus enhance the photovoltaic performances of the solid-state electrolyte DSSCs. With the surface modification of AOT/N719, the succinonitrile based solid-state DSSCs exhibited superior long-term stability, and showed power conversion efficiencies of 6.75% and 7.92% under 1.5 solar spectrum illuminations at 100 and 50 mW cm−2, respectively.
22 August 2011 in Journal of Microelectromechanical Systems
The effects of gamma irradiation on the resonant frequency of a surface-micromachined polysilicon doubly clamped resonator are examined by a laser Doppler vibrometer. The resonant frequency of the resonator decreases by 2.1% for the 500-μm-long beam and 2.7% for the 300- μm-long beam after 32-krad (Si) gamma irradiation. The residual strains of the surface-micromachined polysilicon beams, which are estimated through the change of the resonant frequency, decrease by 2.7% and 5.4% for the 500- and 300-μm-long beams, respectively. Radiation effects of the polysilicon beams have been explained in terms of injection annealing.
Recently, online examination has well developped. As an essential task of online examination, test paper generation plays a critical role. Genetic algorithm has been used in test paper generation systems. However, traditional genetic algorithm is easy to be stuck at local optimal solutions and can not adapt well to the student's mastery of knowledge concepts. In this paper, we propose a novel Multi-population Adaptive Genetic Algorithm (MAGA) for test paper generation. Our algorithm introduces the Longest Common Subsequence(LCS) and Hamming distance to judge genetic similarity and comprehensively considers the influence of evolutionary generation, fitness and genetic similarity on parameters of the proposed algorithm. MAGA constructs the initial population which is then fed into the crossover and mutation operators to be optimized and produce the optimal solution. We conducted experiments for the sequential test paper generation on the datasets. Experimental results demonstrate that our algorithm achieves significant improvement over traditional genetic algorithms with faster convergence speed and higher fitness.