Jarosław Myśków

Jarosław Myśków

Auto-generated profile, based on publicly available information

Jarosław Myśków

Maritime University of Szczecin , Mechanical Engineering Department , Szczecin , Poland

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 April 2013 in IEEE Transactions on Plasma Science
Verified
Journal Article
Closed access
MHMarcin HOŁUB
Marcin HOŁUB
TBTadeusz Borkowski
Tadeusz Borkowski
TJTomasz Jakubowski
Tomasz Jakubowski
SKStanislaw Kalisiak
Stanislaw Kalisiak
JMJaroslaw Myskow
Jaroslaw Myskow
This paper gives an overview of a robust dielectric barrier discharge reactor-catalyst construction used in a bypass of a marine diesel-engine exhaust gas system. Electrode arrangement, housing, and electrode positioning systems are discussed allowing for high temperature and reasonable vibration operation. Preliminary test results are given considering the chemical reactions, particulate matter, and CO and HC reductions. An operative removal efficiency up to 99 percent is obtained (relative percentage units with respect to initial maximal concentrations). The basics of power supply construction and output waveforms are given.

31 December 2021 in Eksploatacja i Niezawodność – Maintenance and Reliability
Verified
Journal Article
Closed access
Przemysław KowalakPrzemysław Kowalak
Przemysław Kowalak
JMJarosław Myśków
Jarosław Myśków
TTTomasz Tuński
Tomasz Tuński
DBDariusz Bykowski
Dariusz Bykowski
TBTadeusz Borkowski
Tadeusz Borkowski
Environmental regulations instigated the technological and procedural revolution in shipping. One of the challenges has been sulfur emission control areas (SECA) and requirement of fuel changeover. Initially, many reports anticipated that new grades of low sulfur fuels might increase various technical problems in ship operation. This research develops a simple and easy to use method of the failure severity and intensity assessment in relation to fuel changeover. The scale of failure rate in the ship’s fuel system was evaluated qualitatively and quantitively, using developed failure frequency indicator and the time between failure. Based on 77 records of fuel system failures collected on seven ships, it has been found that frequency of failures related to SECA fuel changeover is on average nearly three times higher compared to the rest of sailing time. Their severity did not significantly change, but the structure of failures changed considerably. The method and presented results may help in improvement of ship’s systems design and on-board operational procedures.

1 November 2020 in Measurement
Verified
Journal Article
Open access
Przemysław KowalakPrzemysław Kowalak
Przemysław Kowalak
TBTadeusz Borkowski
Tadeusz Borkowski
MBMichał Bonisławski
Michał Bonisławski
MHMarcin Hołub
Marcin Hołub
JMJarosław Myśków
Jarosław Myśków

6 May 2026 in Polish Maritime Research
Verified
Journal Article
Open access
Przemysław KowalakPrzemysław Kowalak
Przemysław Kowalak
JMJarosław Myśków
Jarosław Myśków
New environmental and business requirements mean that inland fleets need to be renewed; however, replacing an entire fleet is generally difficult and expensive. The modernisation of existing vessels may be a viable solution, particularly as this approach is aligned with the requirements for sustainable development and resource conservation. This paper describes a method for assessing the propulsive condition of an existing inland vessel, with a particular focus on the load on the main propulsion system during navigation of empty and loaded ships. One example is an inland pusher vessel, which is subjected to a preliminary analysis here to assess the potential for modernisation. The process of preparing for measurement is described, and the difficulties involved are identified. The analysis is based on measurements of the shaft torque, power and the ship’s speed. The recorded values for the propulsion power, the rotational speed of the propellers and the ship’s speed are presented in the form of graphs as a function of time. The results are given as propeller curves for the domains of the ship’s speed and the rotational speed of the propeller. Based on this analysis of the data, it was found that the propulsion system of a twin-propeller ship is unevenly loaded, with a difference between the loads on the port- and starboard-side propellers of up to 21% of the rated power of the engine. The ship was found to be unable to reach its design speed when loaded with cargo, and barely exceeded 9 km/h compared to the expected 10.5 km/h. Several options for modernisation are proposed.