In this work, we present the results of a fiber optic powered sensor for monitoring partial discharges on high voltage transformer bushings. The main advantages of the proposed system are high bandwidth, passivity, flexibility, non-intrusive, human and equipment risk free, easy installation and inherently galvanic isolation. The complete system is composed by the sensor that is one active hermetically sealed circular antenna installed near to the bushing flange, a fiber network and a control unit. The sensor is powered only by the optical power provided by one optic fiber connected to a remote optical source. At the same time, the partial discharge signals are transmitted by another optical fiber to the control unit installed in the substation room. We describe the design and the performance evaluation of the fiber optic powered antenna in laboratory.
A novel system to monitor methane fugitive emissions was developed using passive optical sensors to attend to the natural gas production and transportation industry. The system is based on optical time domain reflectometry and direct optical absorption spectroscopy. The system was tested in a gas compressor station for four months. The system was capable to measure methane concentration at two points showing its correlation with meteorological data, specially wind velocity and local temperature. Methane concentrations varied from 2.5% to 15% in the first monitored point by sensor 1, and from 5% to 30%, in the second point with sensor 2. Both sensors exhibited a moderate negative correlation with wind velocity with a mean Pearson coefficient of −0.61, despite the external cap designed to avoid the influence of wind. Sensor 2 had a modification to its external package that reduced this mean correlation coefficient to −0.30, considered to be weak to negligible. Regarding temperature, a moderate mean correlation of −0.59 was verified for sensor 1 and zero mean correlation was found for sensor 2. Based on these results the system was proven to be robust for installation in gas transportation or processing facilities.
Passive dissipative balancing requires a lot of heat dissipation and current techniques do not guarantee optimal balance of battery pack energy, requiring a high-cost Battery Management System (BMS) solution which uses resistive components with high power value and fail to detect discrepant cells, possible damaging the BMS balance circuit. In this paper, a new methodology is proposed to perform active dissipative balance of lithium-ion cells with optimized energy management by controlling the source current in order to adjust the recharge rate between the cells in relation to their load level and the detection of discrepant cells based on the voltage values.
We demonstrated a novel methane leak detection system that enables the remote detection and identification of fugitive emission of methane in multiple points employing only one optical fiber and using optical time domain reflectometry and optical frequency scanning in the absorption region of the analyzed gas. Multiple passive remote sensors can be analyzed using a single interrogator equipment with a range of tens of kilometers.