Designing uniform plasmonic surfaces in a large area is highly recommended for surface-enhanced Raman scattering (SERS). As periodic morphologies exhibit uniform SERS and optical tunability, diverse fabrication methods of periodic nanostructures have been reported for SERS applications. Laser interference lithography (LIL) is one of the most versatile tools since it can rapidly fabricate periodic patterns without the usage of photomasks. Here, we explore complex interference patterns for spatially uniform SERS sensors and its cost-effective fabrication method termed multi-exposure laser interference lithography (MELIL). MELIL can produce nearly periodic profiles along every direction confirmed by mathematical background, and in virtue of periodicity, we show that highly uniform Raman scattering (relative standard deviation <6%) can also be achievable in complex geometries as the conventional hole patterns. We quantitatively characterize the Raman enhancement of the MELIL complex patterns after two different metal deposition processes, Au e-beam evaporation and Ag electroplating, which results in 0.387 × 10 5 and 1.451 × 10 5 in enhancement factor respectively. This alternative, vacuum-free electroplating method realizes an even more cost-effective process with enhanced performance. We further conduct the optical simulation for MELIL complex patterns which exhibits the broadened and shifted absorption peaks. This result supports the potential of the expanded optical tunability of the suggested process.
Surfaces become “sticky” at the micro/nano length scale as the gravitational force is no longer effective. Ultragentle, high‐contrast switching of interfacial adhesion is the key to reliable small‐scale object manipulation. Here, a novel approach is presented for surface adhesion control utilizing a liquid‐permeable nanoporous surface, which can switch from off‐state adhesion (< 0.002 kPa) to on‐state attraction (0.8 kPa) without preload. The surface of the gripper is composed of vertically aligned composite nanowires with an average diameter of 79 nm. When a liquid is injected into the nanoporous membrane, capillary adhesion occurs, allowing the object to be picked up. As the liquid evaporates, the object can be released by extremely sparse contact. The off‐state adhesion of a millimeter‐scale gripper is even lower than the gravitational force of thin polymer films (0.18 mN cm −2 ), enabling the solid‐contactless release of lightweight materials. We characterize and model the mechanism across length scales and provide pick‐and‐place demonstrations including LED chips, micro‐architected materials, and thin‐film electronics.
22 September 2025 in Sensors and Actuators A: Physical
Simple adhesive-type safety guards that are currently used are prone to inflow of cutting oil over time, which causes the polycarbonate to shrink. To address this problem, safety guards fabricated by the lamination method are used to prevent inflow of cutting oil and improve impact resistance. Such safety guards are expected to have different impact resistances depending on the mechanical strengths of the lamination films. Impact tests and analysis are thus used to confirm these impact resistance differences based on the bonding strengths of the lamination films. It is noted that the ductility of the material must be reflected in its bonding force and not the mechanical strength. In this study, the results were examined according to the bonding strengths of the lamination films analytically.
28 October 2025 in Journal of Materials Processing Technology
This review systematically examines the design strategies and corresponding analyte delivery and sensing mechanisms of SERS platforms for environmental samples while highlighting the key challenges and future directions in practical applications.