Climate change is increasingly predisposing polar regions to large landslides. Tsunamigenic landslides have occurred recently in Greenland ( Kalaallit Nunaat ), but none have been reported from the eastern fjords. In September 2023, we detected the start of a 9-day-long, global 10.88-millihertz (92-second) monochromatic very-long-period (VLP) seismic signal, originating from East Greenland. In this study, we demonstrate how this event started with a glacial thinning–induced rock-ice avalanche of 25 × 10 6 cubic meters plunging into Dickson Fjord, triggering a 200-meter-high tsunami. Simulations show that the tsunami stabilized into a 7-meter-high long-duration seiche with a frequency (11.45 millihertz) and slow amplitude decay that were nearly identical to the seismic signal. An oscillating, fjord-transverse single force with a maximum amplitude of 5 × 10 11 newtons reproduced the seismic amplitudes and their radiation pattern relative to the fjord, demonstrating how a seiche directly caused the 9-day-long seismic signal. Our findings highlight how climate change is causing cascading, hazardous feedbacks between the cryosphere, hydrosphere, and lithosphere.
19 November 2024 in Natural Hazards and Earth System Sciences
Earthquake hazard analyses rely on seismogenic source models. These are designed in various fashions, such as point sources or area sources, but the most effective is the three-dimensional representation of geological faults. We here refer to such models as fault sources. This study presents the European Fault-Source Model 2020 (EFSM20), which was one of the primary input datasets of the recently released European Seismic Hazard Model 2020. The EFSM20 compilation was entirely based on reusable data from existing active fault regional compilations that were first blended and harmonized and then augmented by a set of derived parameters. These additional parameters were devised to enable users to formulate earthquake rate forecasts based on a seismic-moment balancing approach. EFSM20 considers two main categories of seismogenic faults: crustal faults and subduction systems, which include the subduction interface and intraslab faults. The compiled dataset covers an area from the Mid-Atlantic Ridge to the Caucasus and from northern Africa to Iceland. It includes 1248 crustal faults spanning a total length of ∼95 100 km and four subduction systems, namely the Gibraltar, Calabrian, Hellenic, and Cyprus arcs, for a total length of ∼2120 km. The model focuses on an area encompassing a buffer of 300 km around all European countries (except for Overseas Countries and Territories) and a maximum of 300 km depth for the subducting slabs. All the parameters required to develop a seismic source model for earthquake hazard analysis were determined for crustal faults and subduction systems. A statistical distribution of relevant seismotectonic parameters, such as faulting mechanisms, slip rates, moment rates, and prospective maximum magnitudes, is presented and discussed to address unsettled points in view of future updates and improvements. The dataset, identified by the DOI https://doi.org/10.13127/efsm20 (Basili et al., 2022), is distributed as machine-readable files using open standards (Open Geospatial Consortium).
21 November 2018 in Journal of Geophysical Research: Solid Earth
Contemporaneous mass‐transport deposits (MTDs) recorded in lake and fjord sediments provide evidence of past seismic shaking. However, because they are usually not connected to a fault rupture, assessment of the earthquake source remains difficult. Based on observed coseismic mass wasting and associated seismic shaking, previous studies assigned minimum intensities required to trigger them. Attempts to infer their earthquake source relied on methods developed to estimate the location and magnitude of historical earthquakes using intensity prediction equations, but considered these thresholds as actual intensities. Here we develop a probabilistic method to infer the most likely earthquake sources from the spatial distribution (or absence) of MTDs. This approach simultaneously allows the triggering intensity to exceed the assumed threshold and takes into account intensity prediction equation uncertainties, two shortcomings of existing methods. Additionally, we consider known active faults rather than a grid of possible epicenters. We apply this method to Aysén Fjord (southern Chile), which is intersected by the Liquiñe‐Ofqui Fault Zone. In 2007, an MW = 6.2 earthquake hit the fjord with intensities of VIII+, causing major landslides entering the fjord. Seismic‐reflection profiles show that its sedimentary fill contains nine prehistoric MTD levels. Following a sensitivity analysis, application of the method to the MTD record allows identifying the most likely fault sections and magnitude range for most events, confirming that they are mainly attributed to crustal earthquakes on the Liquiñe‐Ofqui Fault Zone. We conclude that the method has good potential to constrain the size and location of paleoearthquakes for which only shaking evidence is available.
10 January 2006 in Journal of Geophysical Research
Why recent large earthquakes caused shaking stronger than shown on earthquake hazard maps for common return periods is under debate. Explanations include: (1) Current probabilistic seismic hazard analysis (PSHA) is deficient. (2) PSHA is fine but some map parameters are wrong. (3) Low-probability events consistent with a map sometimes occur. This issue has two parts. Verification involves how well maps implement PSHA (“have we built the map right?”). Validation asks how well maps forecast shaking (“have we built the right map?”). We explore how well a map can ideally perform by simulating an area’s shaking history and comparing “observed” shaking to that predicted by a map generated for the same parameters. The simulations yield shaking distributions whose mean is consistent with the map, but individual shaking histories show large scatter. Infrequent large earthquakes cause shaking much stronger than mapped, as observed. Hence, PSHA seems internally consistent and can be regarded as verified. Validation is harder because an earthquake history can yield shaking higher or lower than the hazard map without being inconsistent. As reality gives only one history, it is hard to assess whether misfit between a map and actual shaking reflects chance or a map biased by inappropriate parameters.