26 August 2008 in Environmental Chemistry Letters
1 December 2009 in Ecological Modelling
11 January 2018 in Materials Research
LFLuis Edmundo Fuentes-Cobas
Luis Edmundo Fuentes-Cobas
The purpose of this work is to determine the effective piezoelectric coefficient (d33) and the macro ferroelectric hysteresis behavior for the Ba0.9Ca0.1Ti0.9Zr0.1O3 (BCZT). The sample was prepared by the modified Pechini method and it was sintered at 1250 ºC for 5 h. The refinements of X-ray diffraction (XRD) patterns obtained by the Rietveld method suggest a slight degree of tetragonality (c/a = 1.0025) in the perovskite structure. High counting statistics was performed in the two-dimensional grazing incidence 2D-GIXRD characterization by using synchrotron radiation. These results and the Raman spectrum analysis support the XRD interpretation. The morphology reveals a non-homogeneous terrace-type shape with a grain size distribution centered at 13 microns. The switching spectroscopy piezo-response force microscopy was used to obtained the effective d33 = 142 pm/V. The soft ferroelectric hysteresis shows a coercive field Hc = 1.3 kV/cm with a saturation polarization Ps = 15.7 µC/cm2.
1 July 2017 in Microscopy and Microanalysis
EGE. Guerrero-Lestarjette
+2
25 September 2018 in Journal of the Air & Waste Management Association
MCMartin Bojorquez Carrillo
Martin Bojorquez Carrillo
In the present work, nitrous oxide emissions were estimated [mg/L] by the use of lysimeters under the closed chamber technique for a six month period. The lysimeters were classified by the type of irrigation used: one for drinking water, and the other for treated wastewater. Each lysimeter had two different types of soil (sand and clay), based on the types of soil in Chihuahua City, Mexico. An additional classification based on the depth was done (reticular and vadose zone). Each zone collected gas by the use of a closed chamber technique, allowing the samples to be taken for subsequent quantification and analysis by gas chromatography. A statistical analysis of variance (ANOVA) and principal components analysis (PCA) were conducted to identify the most influential variables or parameters in the formation of nitrous oxide. The variables that were considered for analysis were total Kjeldahl nitrogen (TKN), ammoniacal nitrogen (NH3-N), nitrate nitrogen (NO3-N), and nitrite nitrogen (NO2-N), along with meteorological parameters. In total, 58944 mg/L of N2O were emitted during the measurement period. The results showed that concentration emissions of N2O where the type of soil is sandy were smaller than those of clay soil, while the mean concentration in the vadose zone was higher than those in the reticular zone, regardless the type of soil. The parameters that showed greater influence in the N2O emissions were NO2-N and NO3-N concentrations. Temperature also played an important role in the emissions (the highest emissions were emitted during the cold months). Furthermore, denitrification appeared to be the dominant process in the production of nitrous oxide in soils. Implications: Nitrous oxide (N2O) emissions produced in lysimeters with two types of soil (sand and clay) at two different depths (vadose and reticular zones) using treated waste water showed that the higher emissions of N2O are derived from clay soils in vadose zone; it could be due to the formation of clogging that favors the formation of anoxic conditions for the denitrification process. The parameters that showed more influence in the N2O emissions were nitrite (NO2-N) and nitrate (NO3-N) concentrations along with the temperature.