Earth’s silica-rich continental crust is unique among the terrestrial planets and is critical for planetary habitability. Cratons represent the most imperishable continental fragments and form about 50% of the continental crust of the Earth, yet the mechanisms responsible for craton stabilization remain enigmatic1. Large tracts of strongly differentiated crust formed between 3 and 2.5 billion years ago, during the late Mesoarchaean and Neoarchaean time periods2. This crust contains abundant granitoid rocks with elevated concentrations of U, Th and K; the formation of these igneous rocks represents the final stage of stabilization of the continental crust2,3. Here, we show that subaerial weathering, triggered by the emergence of continental landmasses above sea level, facilitated intracrustal melting and the generation of peraluminous granitoid magmas. This resulted in reorganization of the compositional architecture of continental crust in the Neoarchaean period. Subaerial weathering concentrated heat-producing elements into terrigenous sediments that were incorporated into the deep crust, where they drove crustal melting and the chemical stratification required to stabilize the cratonic lithosphere. The chain of causality between subaerial weathering and the final differentiation of Earth’s crust implies that craton stabilization was an inevitable consequence of continental emergence. Generation of sedimentary rocks enriched in heat-producing elements, at a time in the history of the Earth when the rate of radiogenic heat production was on average twice the present-day rate, resolves a long-standing question of why many cratons were stabilized in the Neoarchaean period.
4 December 2021 in Journal of Geophysical Research: Solid Earth
Studies of the high‐pressure (HP) As Sifah eclogites in the NE Saih Hatat Window, Oman, have used different combinations of radiometric dating results (Ar/Ar, Sm‐Nd vs. U‐Pb, Rb‐Sr) to interpret disparate tectonic models for the timing, geometry, and cause of continental subduction—including its relationship to the Samail Ophiolite. To determine the timing of continental subduction, we coupled petrochronological analyses of major (garnet) and accessory phases (zircon and rutile) from the highest grade metamorphic rocks (As Sifah eclogites) in the Saih Hatat. Early Permian (283.8 ± 0.7 Ma) tuffaceous zircon cores are consistent with earlier interpretations that the As Sifah rocks were sourced from a distal portion of the Arabian continental margin. Data from a range of bulk compositions and metamorphic assemblages consistently suggest a single metamorphic event with garnet growth from ∼81 to 77 Ma—though with slight, consistent offsets in the timing of metamorphic (re)crystallization between different lithologies. These new data confirm previous interpretations for continental HP metamorphism in a single NE‐dipping subduction zone beneath the obducted Samail Ophiolite; there is no robust evidence for an ∼110 Ma event or for SW‐dipping subduction beneath the Arabian plate. Combined with other constraints, our data suggest that the As Sifah unit was subducted at rates similar to other small continental HP bodies, followed by two stages of cooling and exhumation—likely associated with the dragging to mantle depths by a mafic root, an initial phase of rapid exhumation from mantle depths, and a lengthy residence (≤40 My) in the lower to middle crust.
Sand‐shale mélanges from the Kodiak accretionary complex and Shimanto belt of Japan record deformation during underthrusting along a paleosubduction interface in the range 150 to 350 °C. We use observations from these mélanges to construct a simple kinetic model that estimates the maximum time required to seal a single fracture as a measure of the rate of fault zone healing. Crack sealing involves diffusive redistribution of Si from mudstones with scaly fabric to undersaturated fluid‐filled cracks in sandstone blocks. Two driving forces are considered for the chemical potential gradient that drives crack sealing: (1) a transient drop in fluid pressure ∆Pf, and (2) a difference in mean stress between scaly slip surfaces in mudstones and cracks in stronger sandstone blocks. Sealing times are more sensitive to mean stress than ∆Pf, with up to four orders of magnitude faster sealing. Sealing durations are dependent on crack spacing, silica diffusion kinetics, and magnitude of the strength contrast between block and matrix, each of which is loosely constrained for conditions relevant to the seismogenic zone. We apply the model to three active subduction zones and find that sealing rates are fastest along Cascadia and several orders of magnitude slower for a given depth along Nicaragua and Tohoku slab‐top geotherms. The model provides (1) a framework for geochemical processes that influence subduction mechanics via crack sealing and shear fabric development and (2) demonstration that kinetically driven mass redistribution during the interseismic period is a plausible mechanism for creating asperities along smooth, sediment‐dominated convergent margins.
5 January 2023 in Geochemistry, Geophysics, Geosystems
The compositional range of ∼2,000 marine sediments and ∼19,000 oceanic igneous rocks is encapsulated by a set of 12 sedimentary and 10 mafic rock compositions, allowing computation of phase relationships on P‐T paths along subduction interfaces. These are described economically by a partitioning analysis, which connects the mineral assemblages to different parts of the subduction P‐T space and facilitates assessment of prograde dehydration, melting, densification, and rheological systematics. Dehydration and densification occur at shallower depths than in studies that neglect shear heating. Lawsonite stability is limited to interfaces where convergence is slower than 20 mm/yr; such rates also favor transport of volatiles beyond the arc. Terrigenous sediments and mafic rocks reach their solidi close to the top of the wedge‐slab interface; melt fractions are enhanced by fluid from the dehydrating slab interior. Rheological calculations show that the most abundant sediment types have interface capacities of hundreds of meters to kilometers, and that the strengths of mafic rocks comfortably exceed their buoyancy stresses. Above ∼650°C sediments are weak enough to rise as diapirs into the mantle wedge. Carbonate‐ and serpentinite‐rich lithologies are weaker than other interface rocks, and ascend most rapidly at the cessation of subduction. Ascent rates drop abruptly as rocks enter the plate interface, probably leading to retrograde equilibrium at P ∼ 1–1.5 GPa. The seismic‐aseismic transition is expected at about 500°C in mafics, and 400°C in metasediments. Seamounts are weaker than most other interface rocks, and unlikely to form asperities. Slow slip and tremor may be associated with the blueschist‐eclogite transition.