18 October 2018 in IEEE Electron Device Letters
An energy efficient neuron is essential for spiking neural network (SNN) to operate at low energy to mimic the human brain functionalities in hardware. Several CMOS based Si transistors, memory devices, spintronic devices has been used as a neuron for SNN. However, the main concern is the energy efficiency for these neurons. In this paper, we experimentally demonstrate a Si based CMOS compatible asymmetric NIPIN diode as a LIF neuron. First, we demonstrate the LIF neuron characteristics by comparing the spike-frequency (f) versus voltage curve with that of a simple LIF neuron model. This neuron shows a classical ReLU behavior, which is attractive for typical software neuron models. Then, we show an ultra-low energy consumption of ~2 × 10–17J per spike at 10nm node of this neuron, as NIPIN diode is highly scalable (4F2) due to its capacitorless structure. This is the lowest reported energy/spike for any LIF neuron for SNN application. Thus, the NIPIN is suitable for ultra-low energy LIF neuron application for energy efficient SNN.
7 April 2022 in IEEE Transactions on Electron Devices
There are vital challenges to harness the unique assets of germanium (Ge) because of Ge-on-insulator (GeOI) processing issues. The advances in molecular beam epitaxy (MBE) technology have enabled the defect-free growth of atomic-level Ge stacks over the standard monolithic silicon platform to leverage the properties of the Ge as a channel layer. Here, we present the first ever report on the authoritative integration of ferroelectric (FE) hafnium zirconium oxide (HZO) over the p-Ge/n-Ge $_{-on-}\text{n}$ -Si system. A rudimentary approach for the carrier modulation in the channel was employed using depletion approximation and negative capacitance (NC) to fabricate HZO and thin p-Ge channel-based FET. The TaN/HZO/TaN stacks were optimized and characterized for enhanced ferroelectricity and non-centrosymmetric orthorhombic phase, which is further confirmed with piezoresponse force microscopic (PFM) analysis. The trivial loop hysteresis conditions to validate the NCFET operation was discussed. The devices demonstrated a lower subthreshold swing (SS) of ~23.44 mV/dec and ${I}_{ \mathrm{\scriptscriptstyle ON}}/{I}_{ \mathrm{OFF}}$ ratio of 10 5 . The threshold voltage shift ${V}_{t} = -0.6$ and −1.1 V with the body bias voltage of 0.25 and 0.5 V, respectively. Minimum DIBL measured ~26 mV/V, and rule-out gate induces drain lowering (GIDL) effect due to no gate–drain region overlap.
21 June 2021 in IEEE Sensors Journal
In this paper, a near-infrared “Ge-on-Si” camera with backside illumination, is presented. The camera consists of a photonic chip, a readout chip, and a commercial microcontroller, which is connected to a laptop via USB. The functionality of two-dimensional ( 10×10 pixels) as well as one-dimensional ( 64×1 pixel) “Ge-on-Si” pixel arrays with a pitch of 25 μm are demonstrated. The photonic chip consists of basic CMOS technology process in combination with a molecular beam epitaxy growth process. With this technology and the backside illumination a high fill-factor of 74% is achieved. Further the “Ge-on-Si” detectors are operated under zero bias operation in order to minimize the dark current and thus to maximize the signal-to-noise ratio. This enables dark currents better than 100 pA to be achieved in each pixel. A linear behavior between photocurrent and optical power of the “Ge-on-Si” detectors over a large dynamic range for optical powers between 10 -7 W and 10 -2 W is shown. With relatively thin Ge absorption layers of only 400 nm, optical responsivities of 0.36 A/W at a wavelength of 1310 nm could be achieved. The functionality of the “Ge-on-Si” camera is demonstrated by the movement of a single mode fiber over the photonic chip at a wavelength of 1310 nm.
30 March 2021 in IEEE Transactions on Nanotechnology
The quest for the high speed, low power digital logic circuits urge an imperative demand of compatible high-κ dielectric integration on novel Germanium (Ge) based channel material. Here, first ever a methodical nanoscopic and microscopic probes were attempted to Atomic Layer Deposited, Hafnium Dioxide (HfO 2 ) dielectrics on Molecular Beam Epitaxy (MBE) of p-Ge -on- p-Si stack. Kelvin Probe Force Microscopy based contact potential difference (CPD) analysis reveals that the disintegration of trapped charges lasting for ~18 hours. The impact of constant voltage stress (CVS) on trapped charges results in variation of threshold voltage (V th ) and hysteresis window (W) were studied. The cyclic Capacitance-Voltage (C-V) characteristics at 0.5 MHz exhibit the shift in the flat band (ΔV fb ), ΔV th , and ΔW at 10V stress were ~0.84V, ~0.62V, and ~0.47V, respectively. While the computed interface trap density (D it ) and total effective charge density (Q eff ) were ~8.49 × 10 12 eV -1 cm -2 and ~1.81 × 10 12 cm -2 , respectively. The gate leakage current density, (J) at 5V is 26.53 × 10 -6 A/cm 2 and reduced by a factor of ~6.8 after 10V, CVS. Whereas the current density (J) increases from ~26.53 × 10 -6 A/cm 2 at 25 °C by a factor of ~2 at 125 °C. To study the retention and effect of charge trapping, the stress-time analysis was performed for 8000s at 3V (CVS). The r.m.s. surface roughness of HfO 2 thin films was found to be ~0.23 nm. X-ray photoelectron spectroscopy (XPS) depth profiling categorized the elemental composition of thin films. These investigations would help to HfO 2 /p-Ge -on- p-Si system interfacial engineering well before the Ge based nano device realization.
1 August 2016 in Nanotechnology
Spin transport in a semiconductor-based two-dimensional electron gas (2DEG) system has been attractive in spintronics for more than ten years. The inherent advantages of high-mobility channel and enhanced spin–orbital interaction promise a long spin diffusion length and efficient spin manipulation, which are essential for the application of spintronics devices. However, the difficulty of making high-quality ferromagnetic (FM) contacts to the buried 2DEG channel in the heterostructure systems limits the potential developments in functional devices. In this paper, we experimentally demonstrate electrical detection of spin transport in a high-mobility 2DEG system using FM Mn-germanosilicide (Mn(Si 0.7 Ge 0.3 ) x ) end contacts, which is the first report of spin injection and detection in a 2DEG confined in a Si/SiGe modulation doped quantum well structure (MODQW). The extracted spin diffusion length and lifetime are l sf = 4.5 μ m and at 1.9 K respectively. Our results provide a promising approach for spin injection into 2DEG system in the Si-based MODQW, which may lead to innovative spintronic applications such as spin-based transistor, logic, and memory devices.
21 August 2023 in Journal of Vacuum Science & Technology B
Germanium channel FinFET transistors process integration on a silicon substrate is a promising candidate to extend the complementary metal–oxide–semiconductor semiconductor roadmap. This process has utilized the legacy of state-of-art silicon fabrication process technology and can be an immediate solution to integrate beyond Si channel materials over standard Si wafers. The fabrication of such devices involves several complicated technological steps, such as strain-free epi layers over the Si substrate to limit the substrate leakage and patterning of narrow and sharp fins over germanium (Ge). To overcome these issues, the active p-type germanium layers were grown over n-type germanium and virtual substrates. The poly ((4-(methacryloyloxy) phenyl) dimethyl sulfoniumtriflate) was utilized as a polymeric negative tone e-beam resist for sub-20 nm critical dimensions with low line edge roughness, line width roughness, and high etch resistance to pattern p-Ge fins to meet these concerns. Here, the devices use the mesa architecture that will allow low bandgap materials only at the active regions and raised fins to reduce the active area interaction with the substrate to suppress leakage currents. This paper discusses the simple five-layer process flow to fabricate FinFET devices with critical optimizations like resist prerequisite optimization conditions before exposure, alignment of various layers by electron beam alignment, pattern transfer optimizations using reactive ion etching, and bilayer resist for desired lift-off. The Ge-on-Si FinFET devices are fabricated with a width and gate length of 15/90 nm, respectively. The devices exhibit the improved ION/IOFF in order of ∼105, transconductance Gm ∼86 μS/μm, and subthreshold slope close to ∼90 mV/dec.