2 January 2016 in International Journal of Smart and Nano Materials
Due to rapid construction, necessity for raw materials of concrete, especially coarse aggregate, tends to increase the danger of early exhaustion of the natural resources. An alternative source of raw materials would perhaps delay the advent of this early exhaustion. Recycled coarse aggregate (RCA) plays a great role as an alternative raw material that can replace the natural coarse aggregate (NCA) for concrete. Previous studies show that the properties of RCA concrete are inferior in quality compared to NCA concrete. This article attempts to study the improvement of properties of RCA concrete with the addition of bacteria named as Bacillus subtilis. The experimental investigation was carried out to evaluate the improvement of the compressive strength, capillary water absorption, and drying shrinkage of RCA concrete incorporating bacteria. The compressive strength of RCA concrete is found to be increased by about 20% when the cell concentration of B. subtilis is 106 cells/ml. The capillary water absorption as well as drying shrinkage of RCA are reduced when bacteria is incorporated. The improvement of RCA concrete is confirmed to be due to the calcium carbonate precipitation as observed from the microstructure studies carried out on it such as EDX, SEM, and XRD.
1 September 2017 in ASCE-ASME Journal of Risk and Uncertainty in Engineering Systems, Part A: Civil Engineering
The seismic performance of buildings with irregular distribution of mass, stiffness, and strength along the height may be significantly different from that of regular buildings. Design codes prohibit construction or recommend special seismic design of such buildings depending on the level of irregularity and site hazard. It is generally believed that the regular buildings have a dominant fundamental mode participation in their seismic response and as the irregularity increases the contribution of higher mode increases. Accordingly, previous studies have proposed methodologies to quantify the vertical irregularity of the buildings in terms of their fundamental mode properties. This paper checks the adequacy of fundamental mode properties for the quantification of vertical irregularity. Further, this study attempts to check the correlation between existing vertical irregularity indicators and the seismic risk. Seismic risks of selected vertically irregular buildings in terms of fragility curve, annual probability of collapse, and drift hazard curve indicates that there is no correlation between existing vertical irregularity indicators based on fundamental mode properties and seismic risks. Results of seismic risk analysis show building frames with open-ground story and floating columns are found to be more vulnerable than a similar regular building. However, stepped and setback building frames perform even better than a regular frame. Therefore, stepped and setback buildings under the category of vertical geometric irregularity needs to be investigated in detail to validate the special design requirements recommended by design codes.
1 July 2019 in Journal of Materials in Civil Engineering
The strength and stiffness characteristics of infill masonry wall significantly influence the behavior of reinforced concrete framed structures. Although such characteristics for conventional masonry infill walls, like clay and fly ash bricks, are well documented in the literature, experiments for the evaluation of similar properties for modern infill walls using autoclaved aerated concrete (AAC) blocks are limited. This paper reports the experimental results of an investigation of the structural properties of AAC block masonry required for mathematical modeling of AAC masonry-infilled framed structures. It also investigates some of the physical properties of AAC blocks that influence their structural properties and overall behavior.
1 June 2017 in Journal of Materials in Civil Engineering
Bacterially induced mineral precipitation is a general phenomenon in nature. Ureolytic bacteria have been used in many studies as an environmentally friendly method for the protection and improvement of strength of cementitious materials. However, the ammonia produced by ureolytic bacteria during this biomineralization is harmful for the health. This paper incorporates a nonureolytic bacteria of the genus Bacillus, and investigates its effect on various mechanical properties of cement mortar such as compressive strength, setting time, soundness, sorptivity, and microstructural morphology. Outcomes from this study revealed that the nonureolytic bacteria performs better than ureolytic bacteria, as reported by previous studies with regard to compressive strength. The other engineering properties have also been improved by the addition of nonureolytic bacteria. This novel biological precipitation shows promising prospects for increasing the strength and durability of concrete constructions without haz...
5 June 2016 in Earthquake Engineering and Engineering Vibration
2 April 2016 in International Journal of Smart and Nano Materials
Ureolytic-type bacteria has been used to improve the strength of cement mortar by the precipitation of calcium carbonate. In the present study Bacillus sphaericus has been used to improve the properties of cement mortar such as setting time, compressive strength and sorptivity. The setting time is found to be unaffected by the presence of bacteria. It is found that compressive strength at both 7-days and 28-days of mortar cube increases with the increase of bacteria concentration. At the optimum bacteria dosage of 107 cells/ml, the average compressive strength increases by 58% (at 7 day) and 23% (at 28 day) over the control specimen. The sorpitivity coefficient decreases as the concentration of bacterial cells increases. The mineralogy and morphology of the calcium carbonate precipitation have been tested by XRD and FESEM.