17 September 2008 in Physical Review E
The long-time behavior of the first two moments and the correlation function for the output signal of a harmonic oscillator with fluctuating frequency subjected to an external periodic force and an additive thermal noise is considered analytically. The colored fluctuations of the oscillator frequency are modeled as a three-level Markovian noise. Using the Shapiro-Loginov formula, the exact expressions of several stochastic resonance (SR) characteristics such as the spectral amplification, the variance of the output signal, the signal-to-noise ratio, and the SR gain have been calculated. The nonmonotonic dependence of the SR characteristics versus the noise parameters as well as versus the input signal frequency and also the conditions for the appearance of energetic instability are analyzed. In particular, the multiresonancelike behavior of the variance and the signal-to-noise ratio as functions of the noise correlation time are observed and the connection between the occurrence of energetic instability and the phenomenon of stochastic multiresonance is established. Some unexpected effects such as the hypersensitive response of the spectral amplification to small variations of the noise amplitude encountered in the case of a large flatness of the colored noise are also discussed.
1 August 2006 in Physical Review E
A broad class of -species ratio-dependent predator-prey stochastic models, which consist of one predator population and prey populations, is considered. The effect of a fluctuating environment on the carrying capacities of prey populations is taken into account as colored noise. In the framework of the mean-field theory, approximate self-consistency equations for prey-populations mean density and for predator-population density are derived (to the first order in the noise variance). In some cases, the mean field exhibits Hopf bifurcations as a function of noise correlation time. The corresponding transitions are found to be reentrant, e.g., the periodic orbit appears above a critical value of the noise correlation time, but disappears again at a higher value of the noise correlation time. The nonmonotonous dependence of the critical control parameter on the noise correlation time is found, and the conditions for the occurrence of Hopf bifurcations are presented. Our results provide a possible scenario for environmental-fluctuations-induced transitions between the oscillatory regime and equilibrium state of population sizes observed in nature.
1 April 2013 in Journal of Nuclear Materials
1 February 2020 in Fusion Engineering and Design
1 June 2016 in Nukleonika
The influence of extreme heat loads, as produced by a multiple pulses of non-homogeneous fl ow of slow plasma (0.1-1 keV) and fast ions (100 keV), on double-forged tungsten (DFW) was investigated. For generation of deuterium plasma and fast deuterons, plasma-focus devices PF-12 and PF-1000 are used. Depending on devices and conditions, the power flux density of plasma varied in a range of 107-1010 W/cm2 with pulse duration of 50-100 ns. Power flux density of fast ions was 1010-1012 W/cm2 at the pulse duration of 10-50 ns. To achieve the combined effect of different kind of plasmas, the samples were later irradiated with hydrogen plasma (105 W/cm2, 0.25 ms) by a QSPA Kh-50 plasma generator. Surface modification was analysed by scanning electron microscopy (SEM) and microroughness measurements. For estimation of damages in the bulk of material, an electrical conductivity method was used. Investigations showed that irradiation of DFW with multiple plasma pulses generated a mesh of micro- and macrocracks due to high heat load. A comparison with single forged tungsten (W) and tungsten doped with 1% lanthanum-oxide (WL10) reveals the better crack-resistance of DFW. Also, sizes of cells formed between the cracks on the DFW’s surface were larger than in cases of W or WL10. Measurements of electrical conductivity indicated a layer of decreased conductivity, which reached up to 500 μm. It depended mainly on values of power flux density of fast ions, but not on the number of pulses. Thus, it may be concluded that bulk defects (weakening bonds between grains and crystals, dislocations, point-defects) were generated due to mechanical shock wave, which was generated by the fast ions flux. Damages and erosion of materials under different combined radiation conditions have also been discussed.