2 April 2024 in RSC Sustainability
Low value Mn based spinel from an EOL EV battery is selectively leached and upcycled to higher value next generation cathode materials.
9 November 2025 in Advanced Energy and Sustainability Research
Understanding the degradation of large format lithium‐ion pouch cells – critical for electric vehicle applications – is vital to extend their lifetime and allow potential second‐life application. Here, the impact on capacity fade and material degradation in two end‐of‐life cells, which were additionally subjected to accelerated aging to mimic extended use in second‐life applications, were examined using powder synchrotron X‐ray diffraction, Raman spectroscopy and electrochemical impedance spectroscopy, complemented by detailed post mortem analyses. The dominant mechanism of capacity loss under these conditions was found to be lithium inventory depletion, driven by processes such as electrolyte decomposition, lithium plating and solid electrolyte interphase growth. Structural changes in the graphite anode, including amorphization and reduced active material, were more pronounced under severe overcharging conditions. The blended cathode showed lithium inventory loss in both phases, but 92–94% capacity recovery was observed on subsequent cycling in half cells vs Li, illustrating its robustness, with little structural degradation observed. The finding that electrolyte degradation/loss in these cells was a more critical contributor to cell degradation toward the knee‐point than electrode active material degradation/loss indicates that increasing – or replenishing – the electrolyte content could be a strategy to extend the usable life of such cells.
22 November 2023 in ChemRxiv
The increase in the use of electric vehicles (EVs) will ultimately lead to an increase in the number of end-of-life lithium-ion batteries (LIBs) that need to be recycled. A particular challenge concerns how to deal with low value cathodes, such as LiMn2O4 (LMO). To this end, this paper investigates recycling cathode material from an end-of-life Gen 1 Nissan Leaf (2011 model, 40,000 miles) which contains a mixture of spinel (LMO) and a Ni-rich layered oxide (LO). Citric acid was employed to selectively leach LMO into solution while leaving the remaining LO as a solid. The citric acid also acts as a delamination agent to remove the remaining LO from the Al current collector. The LMO was then recovered from solution and upcycled to form new cathode materials. Ni-doping of the solution allowed the synthesis of the high voltage cathode LiMn1.5Ni0.5O4 (LMNO) which is attracting commercial interest. Disordered rocksalt compounds Li4Mn2O5 and Li2MnO2.25F were also synthesised and gave a high specific discharge capacities of 293 and 279 mAh g-1 respectively. This work demonstrates a method to upcycle end-of-life cathode material into next generation cathode materials.
8 August 2025 in ChemRxiv
Driven by increased demand for electric vehicles, the need for lithium-ion batteries has increased reliance on critical materials such as cobalt, nickel and lithium. From production through to end of life there is expected to be a significant amount of valuable, critical materials suitable for recycling. In order to recover these materials and reduce the environmental impact of Li-ion battery waste, effective recycling methods must be implemented without delay. Compared to commonly used recycling methods, direct recycling offers significant benefits including lower cost and lower environmental impact. Direct recycling focuses on minimising extensive reprocessing steps while retaining the materials structure and morphology. Here we have developed a direct recycling approach using hydrothermal and thermal recycling processes to regenerate EoL cathode material. The initial hydrothermal step ensures the polyvinylidene fluoride (PVDF) binder is removed before the final short thermal heat treatments are utilised to regenerate the cathode material. Electrochemical performance shows relithiation during the thermal heat treatment step ensures not only good first cycle efficiency and discharge capacity, but also reduces capacity fade.