1 June 2006 in Corrosion Science
1 January 2006 in Corrosion Science
17 October 2022 in Corrosion Science
1 January 2005 in Journal of the Electrochemical Society
Certain commercial aluminum alloys can become electrochemically activated by heat-treatment as a result of enrichment of the trace element Pb at the surface. For a better understanding of the nature of activation, Pb enrichment resulting from annealing for 1-24 h at 300-600°C in air, followed by quenching in water, was investigated on an AlPb binary model alloy, by use of electrochemical polarization, electron optical techniques, and glow discharge optical emission spectroscopy. Most of the enriched Pb was found to be near the oxide film-aluminum matrix interface, probably in solid solution with aluminum. The surface concentration reached an apparent saturation level of 0.8 wt % at 600°C, up from 20 ppm in the bulk. In addition, segregated metallic Pb particles were detected at an increasing density and size with increasing time of annealing at 600°C. However, segregation of Pb particles did not have an appreciable effect on activation. It is suggested, therefore, that the electrochemical activation is related to reduced passivity of the overlying oxide by Pb enriched in solid solution at the metal surface and ensuing pitting potential depression in the combined presence of aggressive chloride ions in the test solution.
31 March 2026 in SSRN Electronic Journal
Pre-deformation prior to age hardening is an effective approach to increase strength in extruded 6xxx-series aluminum profiles. We systematically investigated how 0-35% pre-deformation combined with artificial ageing affects mechanical properties, precipitate characteristics, and phase evolution in AA6061, with and without 0.1 wt.% Zn. Adding Zn increased strength without reducing elongation in both the undeformed and the pre-deformed condition. For a given artificial ageing time and temperature, strength increased with deformation up to 15% strain before reaching a plateau. At higher strains, the additional work-hardening contribution appears to be counterbalanced by the faster coarsening of the precipitates. Transmission electron microscopy showed that Zn addition increased precipitate density without affecting size, raising the volume fraction. Pre-deformation also increased precipitate density, but a decrease in size resulted in a similar volume fraction as the undeformed condition. High-angle annular dark field scanning transmission electron microscopy revealed a transition from needle-like ordered phases to a mix of structurally disordered needle-like precipitates and lath-like phases. Strength modeling without phase specificity reproduced the behavior of the Zn-free alloy, including a 60 MPa contribution from work-hardening after recovery. While pre-deformation was shown to slightly reduce precipitate strengthening, work-hardening fully explained the net increase in strength.
29 August 2026 in Materials Science and Engineering: A