28 April 2023 in Physical Review Applied
Superconducting nanowire single-photon detectors (SNSPDs) are the highest-performing photon-counting technology in the near-infrared region. Because of delay-line effects, large-area SNSPDs typically trade off timing resolution and detection efficiency. This unavoidable fundamental constraint might limit their future deployment in demanding scientific applications. Here we introduce a detector design based on transmission-line engineering and differential readout for device-level signal conditioning, enabling a high system detection efficiency and a low detector jitter simultaneously. To make our differential detectors compatible with single-ended time taggers, we also engineer analog differential-to-single-ended readout electronics, with minimal impact on the system timing resolution. Our best niobium nitride differential SNSPD achieves a system detection efficiency of at and at . The lowest system jitter is at and at , limited by intrinsic contributions. These detectors also achieve sub-100-ps timing response at 1/100 of the maximum level, at 775 nm and at , enabling time-correlated single-photon counting with high-dynamic-range response functions. Furthermore, because of the differential impedance-matched design, our detectors exhibit delay-line imaging capabilities and photon-number resolution. The properties and high-performance metrics achieved by our system make it a versatile photon-detection solution for quantum computing, quantum communication, and many other scientific applications.
12 June 2023 in Applied Physics Letters
Superconducting nanowire single photon detectors (SNSPDs) are the highest-performing technology for time-resolved single-photon counting from the UV to the near-infrared. The recent discovery of single-photon sensitivity in micrometer-scale superconducting wires is a promising pathway to explore for large active area devices with application to dark matter searches and fundamental physics experiments. We present 8-pixel 1 mm2 superconducting microwire single photon detectors (SMSPDs) with 1 μm-wide wires fabricated from WSi and MoSi films of various stoichiometries using electron-beam and optical lithography. Devices made from all materials and fabrication techniques show saturated internal detection efficiency at 1064 nm in at least one pixel, and the best performing device made from silicon-rich WSi shows single-photon sensitivity in all eight pixels and saturated internal detection efficiency in 6/8 pixels. This detector is the largest reported active-area SMSPD or SNSPD with near-IR sensitivity, and it extends the SMSPD to an array format. By further optimizing the photolithography techniques presented in this work, a viable pathway exists to realize larger devices with cm2-scale active area and beyond.
18 March 2019 in IEEE Transactions on Applied Superconductivity
Photon-number resolving (PNR) single-photon detectors are of interest for a wide range of applications in the emerging field of photon based quantum technologies. Especially photonic integrated circuits will pave the way for a high complexity and ease of use of quantum photonics. Superconducting nanowire single-photon detectors (SNSPDs) are of special interest since they combine a high detection efficiency and a high timing accuracy with a high count rate and they can be configured as PNR-SNSPDs. Here, we present a PNR-SNSPD with a four photon resolution suitable for waveguide integration operating at a temperature of 4 K. A high statistical accuracy for the photon number is achieved for a Poissonian light source at a photon flux below 5 photons/pulse with a detection efficiency of 22.7 ± 3.0% at 900nm and a pulse rate frequency of 76MHz. We demonstrate the ability of such a detector to discriminate a sub-Poissonian from a Poissonian light source.
8 December 2016 in IEEE Transactions on Applied Superconductivity
We investigated the suitability of AlN as a buffer layer for NbN superconducting nanowire single-photon detectors (SNSPDs) on GaAs. The NbN films with a thickness of 3.3-20 nm deposited onto GaAs substrates with an AlN buffer layer demonstrate a higher critical temperature, critical current density, and lower residual resistivity in comparison to films deposited onto bare substrates. Unfortunately, the thermal coupling of the NbN film to the substrate weakens. SNSPDs made of 4.9-nm-thick NbN films on buffered substrates (in comparison to detectors made from NbN films on bare GaAs) demonstrate three orders of magnitude lower dark count rates and about ten times higher detection efficiency at 900 nm being measured at 90% of the critical current. The system timing jitter of SNSPDs on buffered substrates is 72 ps, which is 36 ps lower than those on bare substrate. However, a weaker thermal coupling of NbN nanowire to the buffered substrate leads to a latching effect at bias currents > 0.97 I C .
2 February 2021 in Superconductor Science and Technology
Current crowding at bends of superconducting nanowire single-photon detector (SNSPD) is one of the main factors limiting the performance of meander-style detectors with large filling factors. In this paper, we propose a new concept to reduce the influence of the current crowding effect, a so-called variable thickness SNSPD, which is composed of two regions with different thicknesses. A larger thickness of bends in comparison to the thickness of straight nanowire sections locally reduces the current density and reduces the suppression of the critical current caused by current crowding. This allows variable thickness SNSPD to have a higher critical current, an improved detection efficiency, and decreased dark count rate in comparison with a standard uniform thickness SNSPD with an identical geometry and film quality.