Dina Ahmed El-Gayar

Dina Ahmed El-Gayar

Auto-generated profile, based on publicly available information

Dina Ahmed El-Gayar

Chemical Engineering Department, Faculty of Engineering, Alexandria University, Alexandria, Egypt

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2021 in Chemical Engineering Research and Design
Verified
Journal Article
Closed access
SMSamah Mustafa
Samah Mustafa
MMMahmoud Moharam
Mahmoud Moharam
AZAhmed A. Zatout
Ahmed A. Zatout
GSGomaa H. Sedahmed
Gomaa H. Sedahmed
DEDina A. El-Gayar
Dina A. El-Gayar

24 February 2023 in Scientific Reports
Verified
Journal Article
Open access
PDF file
KZK. K. Zakaria
K. K. Zakaria
HFH. A. Farag
H. A. Farag
DED. A. El-Gayar
D. A. El-Gayar
The present study is concerned with the development of a new cylindrical basket filled with ion exchange resin. The performance of the reactor was examined by removing Cu2+, Fe2+ and SO42− ions from synthetic wastewater. Variables studied were the initial ion concentration in the solution, contact time, resin height inside the cylindrical basket and cylindrical basket rotational speed. Dimensionless analysis was used to obtain a mass transfer correlation for each of the mentioned ions suitable for scale up and design of the present reactor. The experimental results revealed that both the percentage and the rate of removal of (Cu2+, Fe2+ and SO42−) ions decrease as the initial ion concentration in the solution increases, while they increase as the contact time, rotational speed and (L/d) ratio increase. Both Langmuir’s and Freundlich’s adsorption isotherms were examined and it was found that Langmuir’s adsorption isotherm gives a better fitting for the obtained data than Freundlich’s. Regeneration ability was tested, which revealed the high resin efficiency upon operating several consequence cycles that could reach 4 cycles with a slight decrease in the removal efficiency.

1 September 2010 in Chemical Engineering Journal
Verified
Journal Article
Closed access
DED.A. El-Gayar
D.A. El-Gayar
AEA.H. El-Shazly
A.H. El-Shazly
YEY.A. El-Taweel
Y.A. El-Taweel
GSG.H. Sedahmed
G.H. Sedahmed

1 May 2016 in Chemical Engineering Research and Design
Verified
Journal Article
Closed access
DED.A. El-Gayar
D.A. El-Gayar
AKA.H. Konsowa
A.H. Konsowa
YEY.A. El-Taweel
Y.A. El-Taweel
HFH.A. Farag
H.A. Farag
GSG.H. Sedahmed
G.H. Sedahmed

1 December 2017 in Desalination and Water Treatment
Verified
Journal Article
Open access
MHM.A. Hagag
M.A. Hagag
DED.A. El-Gayar
D.A. El-Gayar
SNS.A. Nosier
S.A. Nosier
AMA.A. Mubarak
A.A. Mubarak

11 October 2019 in Current Nanoscience
Verified
Journal Article
Closed access
PDF file
NSNourwanda Mohamed Serour
Nourwanda Mohamed Serour
AHAhmed Salah Eldin Hammad
Ahmed Salah Eldin Hammad
AEAhmed Hassan El-Shazly
Ahmed Hassan El-Shazly
DEDina Ahmed El-Gayar
Dina Ahmed El-Gayar
SNShaaban Attia Nosier
Shaaban Attia Nosier
Background: Graphene-Titanium dioxide nano-composite forms a very promising material in the field of photo-electrochemical research. Methods: In this study, a novel environment-friendly synthesis method was developed to produce well-distributed anatase nano-titanium dioxide spherical particles on the surface of graphene sheets. This novel method has great advantages over previously developed methods of producing graphenetitanium dioxide nanocomposites (GTNCs). High calcination temperature 650°C was used in the preparation of nano titanium dioxide, and chemical exfoliation for graphene synthesis and GTNC was performed by our novel method of depositing titanium dioxide nanoparticles on graphene sheets using a Y-shaped micro-reactor under a controlled pumping rate with minimal use of chemicals. Results: The physiochemical and crystallographic properties of the GTNC were confirmed by TEM, XRD, FTIR and EDX measurements, confirming process repeatability. Spherical nano-titanium dioxide was produced in the anatase phase with very high crystallinity and small particle diameters ranging from 9 nm to 25 nm, also the as prepared graphene (RGO) exhibited minimal flake folding and a high carbon content of 81.28% with a low oxygen-to-carbon atomic ratio of 0.172 and GTNCs produced by our novel method had a superior loading content, a homogeneous distribution and a 96.6% higher content of titanium dioxide particles on the graphene sheets compared with GTNCs prepared with the one-pot method. Conclusion: For its photoelectrochemical properties, chronoamperometry showed that GTNC sample (2) had a higher peak current of 60 μA compared with that of GTNC sample (1), which indicates that the separation and transfer of electron-hole pairs are better in the case of GTNC sample (2) and according to the LSV results, the generation of photocurrent in the samples can be observed through multiple on-off cycles, which indicates that the electrodes are stable and that the photocurrent is quite reversible.