Powder-bed fusion is a class of Additive Manufacturing (AM) processes that bond successive layers of powder to facilitate the creation of parts with complex geometries. As AM technology transitions from the fabrication of prototypes to end-use parts, the understanding of the powder properties needed to reliably produce parts of acceptable quality becomes critical. Consequently, this has led to the use of powder characterisation techniques such as scanning electron microscopy, laser light diffraction, X-ray photoelectron spectroscopy, and differential thermal analysis to study the effect of powder characteristics on part properties. Utilisation of these powder characterisation methods to study particle morphology, chemistry, and microstructure has resulted in significant strides being made towards the optimisation of powder properties. This paper reviews methods commonly used in characterising AM powders, and the effects of powder characteristics on the part properties in powder-bed fusion processes.
Fabrication of dense aluminum (Al-1100) parts (>99.3% of relative density) by our recently developed laser-foil-printing (LFP) additive manufacturing method was investigated as described in this paper. This was achieved by using a laser energy density of 7.0 MW/cm2 to stabilize the melt pool formation and create sufficient penetration depth with 300 μm thickness foil. The highest yield strength (YS) and ultimate tensile strength (UTS) in the LFP-fabricated samples reached 111 ± 8 MPa and 128 ± 3 MPa, respectively, along the laser scanning direction. These samples exhibited greater tensile strength but less ductility compared to annealed Al-1100 samples. Fractographic analysis showed elongated gas pores in the tensile test samples. Strong crystallographic texturing along the solidification direction and dense subgrain boundaries in the LFP-fabricated samples were observed by using the electron backscattered diffraction (EBSD) technique.