27 August 2014 in IEEE Transactions on Industrial Electronics
AMArturo Eduardo Munoz-Castro
Arturo Eduardo Munoz-Castro
+2
The design and construction of a full-bridge flying capacitor multicell inverter (FCMI) composed of two legs is disclosed. Each leg consists of three switching cells. In order to control the power converter, a square wave signal switching technique has been used; the converter output frequency has increased at three times the switching frequency. Moreover, the system can be tuned by a variable inductor coupled with a high-voltage transformer allowing the FCMI to work under a resonance condition from 10- to 30-kHz frequency range. The goal of this converter is to generate a dielectric barrier discharge (DBD) at atmospheric pressure applied in environmental remediation and biological interaction studies. The proposed inverter has been tested with two different DBD reactors, one of them intended for the degradation of organic compound metacresol dissolved in water.
1 January 2017 in Journal of Physics: Conference Series
This work proposes an electrical model that combines homogeneous and filamentary modes of an atmospheric pressure dielectric barrier discharge cell. A voltage controlled electric current source has been utilized to implement the power law equation that represents the homogeneous discharge mode, which starts when the gas breakdown voltage is reached. The filamentary mode implies the emergence of electric current conducting channels (microdischarges), to add this phenomenon an RC circuit commutated by an ideal switch has been proposed. The switch activation occurs at a higher voltage level than the gas breakdown voltage because it is necessary to impose a huge electric field that contributes to the appearance of streamers. The model allows the estimation of several electric parameters inside the reactor that cannot be measured. Also, it is possible to appreciate the modes of the DBD depending on the applied voltage magnitude. Finally, it has been recognized a good agreement between simulation outcomes and experimental results.
28 October 2011 in The European Physical Journal Applied Physics
APA. de la Piedad-Beneitez
+4
A dielectric barrier discharge (DBD) has been successfully applied to studying, both theoretically and experimentally, phenol degradation in waste water aqueous solutions. A coaxial reactor was selected where the liquid waste constitutes a part of the internal electrode itself, the liquid solution flowing up inside the hollow internal electrode impelled by a submersible pump. Thus, the solution falls by gravity on the external surface of the internal electrode. The DBD gas flows in parallel to the surface of the liquid. The cold plasma was generated from Ar-O2 mixture and O2 pure with the inclusion of moisture from the same solution. Two power supplies were compared delivering potentials up to 23 kV at 1.5 kHz, and up to 12 kV at 15.6 kHz respectively. The initial concentration of phenol was around 5 × 10−3 mol/L and efficiencies up to 99% were obtained after 1 h of treatment. Finally, a simplified kinetics model was developed where the temporal evolution of the compounds generated in the phenol degradation process was analyzed. Hydroquinone, catechol and resorcinol were obtained as byproducts and H2O, CO2 and some light carboxylic acids as final products.
2 December 2011 in The European Physical Journal Applied Physics
The design and construction of an instrumentation for NOX degradation in a dielectric-barrier discharge reactor (DBDR) is presented. This is endowed with a parallel plane electrode glass-glass (GG) circular geometry configuration. A solid-state multi-cellular power supply was produced in order to generate the plasma discharge. The power supply is based on a full-bridge voltage inverter commanded by three 4.33 kHz square-wave signals. Thus, the output converter signal is filtered by a resonant LC circuit, providing a 13 kHz sine wave to the DBDR. Initial results showing high removal efficiencies of about 97% have been obtained by means of this instrumentation.
24 May 2017 in Plasma Science and Technology
A new configuration of a resonant full-bridge flying capacitor multicell inverter has been designed and constructed with the aim of achieving an extended output voltage frequency range with low harmonic distortion and reduced semiconductor commutation losses. This configuration was tested as a power supply for two different coaxial dielectric barrier discharge reactors, one of them employed for electric characterization and the other one for inorganic compound elimination in an aqueous solution. Two different gas mixtures, 90% Ar–10% O2 and 80% Ar–20% O2, were individually supplied during the experiments; the results showed a high-efficiency removal of meta-cresol (m-cresol) to the order of 98%, which was obtained by adding more oxygen to the plasma gas mixture.