For copper-tantalum, aluminum-tantalum, and magnesium-titanium joints the character of the interface relief has been investigated in different regimes of explosion welding at, below, and above the...
The paper studies the interface relief of copper–tantalum, copper–titanium and copper–copper joints. It demonstrates that interfaces could be considered as a fractal object. Fractal dimensions are calculated for these joints. A rule is established for the behavior of the fractal dimension during the transition from flat interfaces to wavy ones; this rule holds true of all joint pairs. Some behavior specifics are found for the fractal dimension of wavy interfaces of the copper–copper joint (which was substituted with Cu-Cu80Ni20 joint for convenience). The study shows that the fractal dimension in general decreases when welding modes are intensified. However, in the case of welding modes that are close in terms of energy input, certain peculiarities or deviations from such behavior can be observed. Graphical Abstract
The paper studies the interface behavior of multi-layered Cu-Ta composites successfully produced by means of single-shot explosive welding technique. It is found that the transition zone may have three states at the same time: smooth interface, flat interface (consisting of individual cusps) and wavy interface also. The study shows the role of mutual solubility of initial elements in the formation of a welded joint structure. Based on electron microscopic studies, multi-layered composite is compared with two-layered Cu-Ta composites. Similarities of the interface microstructure elements and hardening behavior as well as reasons for the differences between them are discussed.
24 September 2015 in Bulletin of the Russian Academy of Sciences: Physics
Planar and wavy interface reliefs of copper–tantalum joints made via explosive welding are investigated. A set of typical interface structures that replace one another as the welding regime intensifie