17 June 2018 in Transportation Research Record: Journal of the Transportation Research Board
Speed profiles can be considered as a key input for assessing safety, comfort and efficiency of highway or expressway segments. Therefore, understanding drivers’ speeding behavior, particularly on expressway curve sections, is important. Most previous studies have modeled the speed on highway curve sections mainly as constant or a piecewise linear profile. Such approaches may not realistically represent the properties of speed and acceleration behavior. Furthermore, mechanisms underlying the speeding behavior through curve sections have not been comprehensively studied. In this study, the minimum-jerk concept, which was originally applied in neuroscience and robotics domains, is utilized to explore drivers’ speeding behavior on expressway curve sections. GPS-based naturalistic driving data of vehicles travelling on the Tomei expressway in Japan under free-flow conditions were used to explore the applicability and validity of the proposed approach. How the proposed approach can be used to evaluate the effect of horizontal geometry and desired driving speed on drivers’ speeding and acceleration behavior on expressway curve sections is also discussed. The findings of this study could be useful in modeling speed and acceleration choice behaviors on highway curve sections which could potentially be applied in highway design consistency evaluations. Furthermore, the outputs of this study may be useful in other advanced applications, such as modeling and visualizing realistic vehicle movements in driving simulators and virtual reality applications and trajectory planning of autonomous vehicles.
18 September 2026 in International Journal of Geo-Engineering
Working platforms are critical temporary geotechnical structures used to support heavy construction equipment operating over weak cohesive subgrades. Their performance depends on the ability of the platform system to distribute applied stresses, mobilise sufficient bearing resistance, and maintain operational stability. Conventional design methods are largely based on unreinforced two-layer foundation theory and empirical guidance, with limited provisions for quantifying geosynthetic reinforcement effects. Although recent industry guidance recognises the benefits of geosynthetics, experimentally validated, design-oriented methodologies remain limited. This study experimentally investigates the reinforcement effect of geocomposites, which are hybrid geosynthetics combining geogrid reinforcement and geotextile separation, installed at the subgrade–capping layer interface. Large-scale static plate load tests were conducted in an instrumented steel model box (1.0 m × 1.0 m × 1.2 m) to simulate field-representative boundary and loading conditions. Soft clay subgrades were prepared to target California Bearing Ratio (CBR) values of 2.5% and 1.0%. Monotonic loading was applied through a 200 mm diameter plate at a displacement rate of 1.0 mm/min to evaluate the influence of capping layer thickness, subgrade stiffness, and geocomposite inclusion on ultimate bearing capacity and stress distribution. Results show that geocomposite inclusion significantly increases ultimate bearing capacity, with the greatest relative improvement observed at lower capping thicknesses. Beyond a critical thickness, additional granular material provides diminishing gains. A performance-based design chart was developed to estimate required capping thickness for target bearing capacity in reinforced working platforms, supporting cost-effective and structurally efficient design over soft cohesive subgrades.