Geosynthetic clay liners (GCLs) were exhumed from composite barriers, (i.e., geomembrane over GCL) in final covers at four sites after 4.7 to 6.7 years to evaluate the in-service condition. Monovalent bound cations were replaced by divalent cations in all GCLs, with near complete exchange at two-thirds of the sampling locations. Hydraulic conductivity was measured using two dilute solutions commonly used as permeant water: standard water (SW, 0.01M CaCl2 solution) and type II deionized water (DW). Hydraulic conductivities to SW varied over four orders of magnitude, whereas identical specimens (i.e., from same sample) had hydraulic conductivities to DW consistently ≤3× 10−10 m/s . Higher hydraulic conductivities and sensitivity to permeant water did not correspond directly to the amount of cation exchange. Exhumed GCLs with higher gravimetric higher water contents ( >50% ) exhibited a gel structure indicative of osmotic hydration and had lower hydraulic conductivities to both SW and DW, regardless of the ...
1 April 2013 in Journal of Geotechnical and Geoenvironmental Engineering
Experiments were conducted to evaluate cation exchange during hydration of geosynthetic clay liners (GCLs) used in composite hydraulic barriers and the effect on their hydraulic conductivity. GCLs arranged in a composite barrier configuration were hydrated by contact with moist compacted subgrades (two clays, one silt, and one sand) under a confining stress of 10 kPa for 30 days to 1 year. No measurable exchange occurred in GCLs hydrated for 30 days. For hydration periods longer than 30 days, the exchange increased as the duration of hydration increased. The exchange during subgrade hydration had no measurable effect on the hydraulic conductivity to deionized (DI) water. However, if the GCL was desiccated after hydration, the hydraulic conductivity increased more than 1,000-fold. Dissolution of calcite within the bentonite during permeation with DI water also induced the replacement of sodium by calcium; however, this additional exchange had no measurable effect on the hydraulic conductivity to DI...
Bentonite was modified at the nanoscale so that low hydraulic conductivity would be maintained under adverse conditions. Nanoscale modification consisted of polymerizing acrylic acid within a bentonite slurry to form a stable interconnected structure. This modified material is referred to as a bentonite-polymer nanocomposite (BPN). The BPN was then air dried and ground to simulate the granule-size distribution of granular bentonite in geosynthetic clay liners (GCLs). Index property tests indicate that BPN has different behavior than natural sodium bentonite (Na-bentonite). For example, free swell tests with natural Na-bentonite swelled to approximately 30 mL in deionized water, whereas BPN swelled to more than 70 mL in the same solution. GCLs were assembled and directly permeated with a range of calcium chloride (CaCl2) solutions known to cause large increases in the hydraulic conductivity (k) of natural Na-bentonite. Low hydraulic conductivities (k < 3 x 10–10 cm/s) were maintained by BPN for all solutions tested. In contrast, natural Na-bentonite tested under the same conditions had k more than 4 orders of magnitude higher (k > 2 x 10–5 cm/s). Additional study of the properties and the underlying mechanisms of BPN are ongoing.