Monolayer-protected Au, Ag, and Au:Ag alloy nanoclusters have been synthesized using octanethiol and octadecanethiol as capping agents. The particle-size distribution is narrow with an average core size of 3–4 nm. Optical nonlinearity induced by 35 ps pulses at 532 nm has been investigated in these samples using the Z-scan technique. It is found that in general, they behave either as saturable absorbers or reverse saturable absorbers depending on the intensity of excitation. Au and Ag clusters show nearly the same efficiency for optical limiting, but the alloy clusters are found to be less efficient in limiting and are less photostable. The observed effects are explained in terms of the electron dynamics of the excited-state species.
10 July 2019 in ACS Biomaterials Science & Engineering
An enhancement in the photocatalytic degradation of low-density polyethylene (LDPE) under solar radiation was accomplished by incorporating titania nanoparticles (TiO2) of size 15 nm in the polythene matrix. The LDPE–TiO2 nanocomposite film was prepared through a simple solution casting technique with 0.1 wt% TiO2 nanoparticles. The photocatalytic degradation of the LDPE–TiO2 nanocomposite was investigated using FE-SEM, FT-IR, XPS, XRD, TGA and photoinduced weight loss analysis. To ensure the wide applicability of the method in environmental remediation, the photocatalytic degradation was carried out under solar radiation. We observed that, when exposed to solar radiation, the composite films showed a significant weight loss of 68% within a period of 200 h, which is a remarkable improvement compared to the previous reports. FT-IR and XPS analysis confirmed the presence of carbonyl groups with a carbonyl index of 19, which led to the degradation of LDPE. FE-SEM analysis revealed the mechanism of degradation of the LDPE matrix on the surface of TiO2 through the formation of pores at the interface. Thus we put forward the development of eco-friendly photodegradable plastic as a solution for the growing concerns of plastic pollution.
1 April 2013 in Colloids and Surfaces A: Physicochemical and Engineering Aspects