We have demonstrated an on-wafer fabrication process for AlGaN-based UV-C laser diodes (LDs) with etched mirrors and have achieved lasing for 100 ns pulsed current injection at room temperature. A combined process of dry and wet etching was employed to achieve smooth and vertical AlGaN (1 00) facets. These etched facets were then uniformly coated with a distributed Bragg reflector by atomic layer deposition. A remarkable reduction of the lasing threshold current density to was obtained owing to the high reflectivity of the etched and coated mirror facets. The entire laser diode fabrication process was carried out on a whole 2-in. wafer. We propose this mirror fabrication process as a viable low-cost AlGaN-based UV-C LD production method that is also compatible with highly integrated optoelectronics based on AlN substrates.
Although the pulsed operation of AlGaN-based laser diodes at UV-C wavelengths has been confirmed in the previous studies, continuous oscillation without cooling is difficult because of the high operating voltage. In this study, the temperature dependence of key parameters was investigated and their impact on achieving continuous-wave lasing was discussed. A reduction in the threshold voltage was achieved by tapering the sides of the laser diode mesa and reducing the lateral distance between the n- and p-electrodes. As a result, continuous-wave lasing at room temperature was demonstrated at a threshold current density of and a threshold voltage of .
We demonstrated continuous-wave lasing of an AlGaN-based ultraviolet laser diode, fabricated on a single-crystal AlN substrate when operating at 5 °C. The threshold current density and device series resistance were reduced by improvements to the epitaxial structure and electrode arrangement. A peak wavelength of 274.8 nm was observed for lasing at a drive current over 110 mA, which corresponded to a threshold current density of 3.7 kA cm−2. The operating voltage at the threshold current was as low as 9.6 V.
14 August 2020 in Japanese Journal of Applied Physics
We present an optical modeling and characterization study of prototype ultraviolet laser diode (LD) structures grown on single-crystal AlN substrates, with focus on the reduction of modal loss caused by optical mode coupling to the absorptive layers on the p-side (i.e. p-contact and p-metal layers). The transparent AlN substrates enabled optical pumping for measuring modal loss without requiring functioning LDs. The modal loss measured in this way was in good agreement with electrically evaluated results of processed LDs, and both results were consistent with optical modeling predictions. By using 0.32 μ m thick p-side cladding, we were able to suppress the modal loss of the designed LD structure to 8.4 cm −1 , where the contribution from the absorptive p-contact layers was less than 3 cm −1 .
The space charge density profile of the nondoped AlGaN-based p-type cladding layer for UV-C laser diodes realized by distributed polarization doping is examined theoretically and experimentally. The analysis of the capacitance-voltage measurement revealed that the average effective acceptor density of 4.2 × 1017 cm–3 is achieved even without impurity doping, and it is in good agreement with the theoretical prediction from the measured Al composition profile. This result suggests that the cladding layer is ideal for UV-C LDs because it provides sufficient hole injection while potentially avoiding internal losses due to impurity doping.