1 April 2017 in International Journal of Mechanical Sciences
Most current analysis of nano-indentation test data assumes the sample to behave as an isotropic, homogeneous body. In practice, engineering materials such as structural steels, titanium alloys and high strength aluminium alloys are multi-phase metals with microstructural length scales that can be the same order of magnitude as the maximum achievable nano-indentation depth. This heterogeneity results in considerable scatter in the indentation load-displacement traces and complicates inverse analysis of this data. To address this problem, an improved and optimised inverse analysis procedure to estimate bulk tensile properties of heterogeneous materials using a new ‘multi-objective’ function has been developed which considers nano-indentation data obtained from several indentation sites. The technique was applied to S355 structural steel bulk samples as well as an autogenously electron beam welded sample where there is a local variation of material properties. Using the new inverse analysis approach on the S355 bulk material resulted in an error within 3% of the experimental yield strength and strain hardening exponent data, which compares to an approximate 9% error in the yield strength and an 8% error in the strain hardening exponent using a more conventional approach to the inverse analysis method. Applying the new method to indentation data from different regions of an S355 steel weld and using this data as an input into an FE model of the cross-weld, tensile data from the FE model resulted matching the experimentally measured properties to within 5%, confirming the efficacy of the new inverse analysis approach
18 February 2022 in Science Advances
The plasma-facing components of future fusion reactors, where the Eurofer97 is the primary structural material, will be assembled by laser-welding techniques. The heterogeneous residual stress induced by welding can interact with the microstructure, resulting in a degradation of mechanical properties and a reduction in joint lifetime. Here, a Xe + plasma focused ion beam with digital image correlation (PFIB-DIC) and nanoindentation is used to reveal the mechanistic connection between residual stress, microstructure, and microhardness. This study is the first to use the PFIB-DIC to evaluate the time-resolved multiscale residual stress at a length scale of tens of micrometers for laser-welded Eurofer97. A nonequilibrium microscale residual stress is observed, which contributes to the macroscale residual stress. The microhardness is similar for the fusion zone and heat-affected zone (HAZ), although the HAZ exhibits around ~30% tensile residual stress softening. The results provide insight into maintaining structural integrity for this critical engineering challenge.
16 June 2016 in International Journal of Applied Ceramic Technology
Glass‐ceramics are widely utilized in the electronics industry to provide electrical insulation and to form leak‐tight joints with a range of metals. The coefficient of thermal expansion ( CTE ) of the glass‐ceramic can be controlled by the extent of crystallization to reduce detrimental tensile stresses in the joint. In recent years, there has been interest in using titanium alloys, in place of stainless steels, due to their lower density and superior specific strength. In this study, the heat treatment of a strontium boroaluminate glass has been tailored to create glass‐ceramics with mean CTE s ranging from 5.7 ± 0.1 × 10 −6 /K to 9.7 ± 0.1 × 10 −6 /K over the temperature range 303–693 K. The resultant glass‐ceramic consists of three crystalline phases and residual glass. A glass‐ceramic with a mean CTE of 6.9 ± 0.1 × 10 −6 /K was subsequently fabricated to form a compression seal with a Ti–6Al–4V housing and a preoxidized Kovar pin. Single pin assemblies were shown to be reproducible in terms of microstructure and all passed a standard helium leak test, indicating that a successful seal had been produced.
19 March 2001 in Acta Materialia
1 November 2013 in International Journal of Heat and Mass Transfer