1 April 2022 in Mechanical Systems and Signal Processing
12 October 2022 in Reliability Engineering & System Safety
1 March 2022 in IEEE/ASME Transactions on Mechatronics
Nowadays, transfer learning and domain adaptation are widely used in prognostics and health management of rotating machinery, greatly broadening its applications in scenarios with multiple operating conditions. However, almost all existing prognostic methods employ a single-source domain adaptation (SDA), ignoring the domain-shift within the source domain, and fail to make full use of multi-source historical data. To overcome these drawbacks, a multisource domain adaptation network (MDAN) for regression tasks is proposed in this article. MDAN learns domain-invariant features and supervision from multiple sources and provides better generalization in the target domain than traditional SDA methods. Besides, a new MDAN-based framework is presented for remaining useful life prediction of bearings under multiple operating conditions. Specifically, we input the time-frequency representation of the vibration signals into MDAN to achieve end-to-end training and inference across operating conditions. Case studies on the run-to-failure datasets validate the effectiveness of proposed method, and the comparison shows that it outperforms the state-of-the-art methods.
26 August 2022 in IEEE Transactions on Industrial Informatics
Deep neural networks have promoted the technology development of fault classification and remaining useful life prediction (RUL) for mechanical equipment due to their powerful nonlinear feature extraction capability. However, the performance of traditional deep learning models is limited by the depth of networks, which is directly related to the training consumption. In addition, the parameters of networks can only be updated by retraining when faced with newly acquired data. To address the above problems, an incremental learning method based on temporal cascaded broad learning system (TCBLS) is proposed for RUL prediction of machinery with newly acquired data. Specifically, linear and nonlinear feature information is first learned by TCBLS. The ridge regression method is developed to calculate the weights of network and establish an end-to-end mapping between the feature information layer and the prediction layer. Finally, incremental learning of new data and incremental learning of nodes are proposed for adaptively updating the weights of the network in the face of newly acquired data and insufficient prediction accuracy. The effectiveness of the proposed method is verified by four run-to-failure datasets respectively. The comparison results with classical deep learning models show that the proposed method is promising for RUL prediction as it achieves high prediction accuracy while saving training time consumption across orders of magnitude and effectively handling newly acquired data without retraining.
30 April 2021 in IEEE Transactions on Instrumentation and Measurement
Transfer learning (TL) and domain adaptation (DA) have aroused the interest of many researchers and are used in the prognostics and health management (PHM) of bearings. However, traditional DA methods tend to lose fine-grained information when aligning the domains globally. Moreover, most DA methods are not suitable for regression tasks, such as remaining useful life (RUL) prediction. This article proposes a deep subdomain adaptive regression network (DSARN), which can align the relevant subdomains in the source and target domains. This method has good cross-domain generalization ability and thus can be used for RUL prediction of bearings under multiple operating conditions. The proposed method takes the multichannel time-frequency representation (TFR) of bearings as the input and uses DSARN to extract the domain-invariant hidden representation and to establish a mapping to RUL. The effectiveness of the proposed method is verified by case studies on bearings. A comparison with other state-of-the-art deep learning (DL) and TL methods also proves the superiority of the proposed method.
4 November 2022 in ACS Nano