We propose dual-wavelength Fourier ptychography for topographic measurement. To extend the axial measurement range, a single light-emitting diode (LED) and two appropriate bandpass filters are employed. This provides a speckle-free phase image, and reduces the possibility of a systematic error, which yields a high-quality topographic image. The proposed system can measure the surface topography in the range of nano- to micro-structures. The performance of the system is experimentally verified.
Plasmonic lithography has been used in nanofabrication because of its utility beyond the diffraction limit. The resolution of plasmonic lithography depends on the nano-gap between the nanoaperture and the photoresist surface—changing the gap distance can modulate the line-width of the pattern. In this letter, we demonstrate solid-immersion lens based active non-contact plasmonic lithography, applying a range of gap conditions to modulate the line-width of the pattern. Using a solid-immersion lens-based near-field control system, the nano-gap between the exit surface of the nanoaperture and the media can be actively modulated and maintained to within a few nanometers. The line-widths of the recorded patterns using 15- and 5-nm gaps were 47 and 19.5 nm, respectively, which matched closely the calculated full-width at half-maximum. From these results, we conclude that changing the nano-gap within a solid-immersion lens-based plasmonic head results in varying line-width patterns.
There has been much research about STED microscopy to reduce cost. In that microscopy, it is necessary to synchronize the pulsed lights which is just for initial setup. However, there has not been researched in order to reduce this expense until now. So, in this paper, we propose the low-cost strategy to measure the time delay in STED microscopy. To achieve that, we utilized TCSPC principle with a general digital oscilloscope. As a result, we attained successful measurement and adjustment about two pulsed lights with 180-ps delay in STED system.