27 November 2017 in Journal of the American Chemical Society
Conventional chemical oxidation routes for the production of graphene oxide (GO), such as the Hummers’ method, suffer from environmental and safety issues due to their use of hazardous and explosive chemicals. These issues are addressed by electrochemical oxidation methods, but such approaches typically have a low yield due to inhomogeneous oxidation. Herein we report a two-step electrochemical intercalation and oxidation approach to produce GO on the large laboratory scale (tens of grams) comprising (1) forming a stage 1 graphite intercalation compound (GIC) in concentrated sulfuric acid and (2) oxidizing and exfoliating the stage 1 GIC in an aqueous solution of 0.1 M ammonium sulfate. This two-step approach leads to GO with a high yield (>70 wt %), good quality (>90%, monolayer), and reasonable oxygen content (17.7 at. %). Moreover, the as-produced GO can be subsequently deeply reduced (3.2 at. % oxygen; C/O ratio 30.2) to yield highly conductive (54 600 S m–1) reduced GO. Electrochemical capacitors based on the reduced GO showed an ultrahigh rate capability of up to 10 V s–1 due to this high conductivity.
26 February 2020 in ACS Applied Materials & Interfaces
1 January 2019 in Journal of Southwest Jiaotong University
The article describes a new way to the synthesis of silver nanoparticles based on UV-irradiation energy. Our technique allows for producing high quality and clean nanoparticles. Moreover, our photolysis approach allows us to synthesis silver nanoparticles (Ag NPs) with very low cost and short time. The nanostructures were characterized using X-ray diffraction, transmission electron spectroscopy and UV-visible spectrometer. Most of the Ag NPs are shown to be a hexagonal shape and some of them are a spherical shape. The average size of nanoparticles was calculated to be around 20.23 nm. The morphology, size, and ion concentration of the synthesized Ag NPs determine their absorbance and transmittance at the UV region of spectrum. Silver's antimicrobial properties are well known and due to their antimicrobial activity, silver nanoparticles become more important. Therefore, our synthesized Ag NPs were used against Staphylococcus aureus (Gram-positive bacteria) and E. coli (Gram-negative bacteria). The results show that the nanoparticles at a concentration of 0.2 mg/ml demonstrated a high activity of antimicrobials, resulting in a good inhibition for both grams positive and negative bacteria. However, the effect of Ag NPs on gram-positive bacteria is higher than gram-negative bacteria.
1 February 2020 in Egyptian Journal of Chemistry
A modification of an UV-irradiation method is used to synthesis of Cr2O3 nanoparticles. It is a simple and easy way to produce small particles of chromium oxide at a range of 2 – 30 nm according to the transmission electron microscopy (TEM) and X-ray diffraction (XRD) characterizations. In this study, the synthesized nanoparticles are used as an adsorbent for zinc ions from their aqueous solutions under effect of different temperatures 15, 25, 35, 45 and 55 oC. The adsorption process of zinc ions is endothermic (ΔH is 10.33 kJ/mol ) and its data fitted well with the Freundlich isotherm model (R2=0.9601). The data of adsorption show non-spontaneously in nature when the thermodynamic parameter ΔG is positive (1.515 kJ/mol). However, the ΔG changes to a negative value with the temperature rising and the process begins spontaneously because the adsorption capacity increases with increase in temperature.
27 August 2026 in Bulletin of the Russian Academy of Sciences: Physics
Magnetic hysteresis loops of the nanostructure ceramic samples of BiFeO3 subjected to neutron and γ-irradiation, as well as the initial sample, were studied at room temperature. Their electrical and dielectric properties were studied within the temperature range of 30–500°C at a frequency of 100 kHz. The experiment revealed a weakening of the magnetic response of BiFeO3 because of exposure to ionizing radiation. The effect of radiation on the dielectric and electrical properties of the material is discussed.