A circular electron positron collider (CEPC) will adopt hundreds of 650-MHz superconducting cavities with high quality factor (Q) and accelerating gradient (Eacc). Two 650-MHz single-cell cavities made of fine-grain niobium were first treated via buffered chemical polishing (BCP), which was easy and convenient. However, the vertical test results could not meet the specification of the CEPC (4 × 1010 at 22 MV/m). Therefore, electro-polishing (EP) of 650-MHz single-cell cavities was conducted, which was complicated but remarkably effective. Both 650-MHz single-cell cavities achieved state-of-the-art gradients of 35 MV/m after the EP process, which is extremely high for large elliptical cavities (frequency < 1 GHz). One cavity achieved an intrinsic quality factor (Q0) of 4.5 × 1010 at 22.0 MV/m, which was higher than the CEPC spec. The other cavity obtained a lower Q0 of 3.4 × 1010 at 22.0 MV/m, which may have resulted from the cancellation of high-temperature annealing.
1 November 2017 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Medium-temperature (mid-T) furnace baking was conducted at 650 MHz superconducting radio-frequency (SRF) cavity for circular electron positron collider (CEPC), which enhanced the cavity unloaded quality factor (Q0) significantly. In the vertical test (2.0 K), Q0 of 650 MHz cavity reached 6.4 × 1010 at 30 MV/m, which is remarkably high at this unexplored frequency. Additionally, the cavity quenched at 31.2 MV/m finally. There was no anti-Q-slope behavior after mid-T furnace baking, which is characteristic of 1.3 GHz cavities. The microwave surface resistance (RS) was also studied, which indicated both very low Bardeen–Cooper–Schrieffer (BCS) and residual resistance. The recipe of cavity process in this paper is simplified and easy to duplicate, which may benefit the SRF community.
19 October 2020 in Radiation Detection Technology and Methods
Superconducting β=1 quarter-wave geometry of 166.6 MHz has been proposed as main accelerating cavities for the High Energy Photon Source (HEPS) storage ring. HEPS is a 6 GeV kilometer-scale synchrotron light source promising ultralow emittance currently being constructed in Beijing. A proof-of-principle cavity has been previously in-house developed and vertical tested achieving excellent cryogenic performances. A helium jacket was subsequently designed adopting a simple structure and an integrated magnetic field shielding. The mechanical properties of the dressed cavity were largely improved focusing on pressure sensitivity, stress and Lorentz force detuning, while frequency tunability and microphonics were carefully monitored. Elastic buckling and fatigue were also examined. The helium jacket was later fabricated and welded directly with the niobium cavity. Mounted with an input power coupler and tuners, the dressed cavity was finally assembled in a modified cryomodule and tested at both 4.2 K and 2.0 K. The favored low pressure sensitivity and small Lorentz force detuning was confirmed. Microphonics spectrum was scanned and measured, presenting good consistencies with simulation predictions. Finally, the cavity was successfully tuned to the operating frequency of 166.6 MHz at cold and its frequency could be regulated within +/-3 Hz range. This paper covers the mechanical aspects in the development and horizontal cryogenic tests of the first dressed 166.6 MHz superconducting cavity.