Merging photonic structures and optoelectronic sensors into a single chip may yield a sensor‐on‐chip spectroscopic device that can measure the spectrum of matter. In this work, an on‐chip concurrent multiwavelength infrared (IR) sensor, which consists of a set of narrowband wavelength‐selective plasmonic perfect absorbers combined with pyroelectric sensors, where the response of each pyroelectric sensor is boosted only at the resonance of the nanostructured absorber, is proposed and realized. The proposed absorber, which is based on Wood's anomaly absorption from a 2D plasmonic square lattice, shows a narrowband polarization‐independent resonance (quality factor – Q of 73) with a nearly perfect absorptivity as high as 0.99 at normal incidence. The fabricated quad‐wavelength IR sensors exhibit four different narrowband spectral responses at normal incidence following the predesigned resonances in the mid‐wavelength infrared region that corresponds to the atmospheric window. The device can be applied for practical spectroscopic applications such as nondispersive IR sensors, IR chemical imaging devices, pyrometers, and spectroscopic thermography imaging.
The electrical hysteresis in current–voltage (I–V) and capacitance–voltage characteristics was observed in an atomic-layer-deposited Al2O3/p-GaN metal–oxide–semiconductor capacitor (PMOSCAP). The absolute minimum leakage currents of the PMOSCAP for forward and backward I–V scans occurred not at 0 V but at −4.4 and +4.4 V, respectively. A negative flat-band voltage shift of 5.5 V was acquired with a capacitance step from +4.4 to +6.1 V during the forward scan. Mg surface accumulation on p-GaN was demonstrated to induce an Mg–Ga–Al–O oxidized layer with a trap density on the order of 1013 cm−2. The electrical hysteresis is attributed to the hole trapping and detrapping process in the traps of the Mg–Ga–Al–O layer via the Poole–Frenkel mechanism.
To examine the potential of organic thermoelectrics (TEs) for energy harvesting, we fabricated an organic TE module to achieve 250 mV in the open-circuit voltage which is sufficient to drive a commercially available booster circuit designed for energy harvesting usage. We chose the π-type module structure to maintain the temperature differences in organic TE legs, and then optimized the p- and n-type TE materials’ properties. After injecting the p- and n-type TE materials into photolithographic mold, we eventually achieved 250 mV in the open-circuit voltage by a method to form the upper electrodes. However, we faced a difficulty to reduce the contact resistance in this material system. We conclude that TE materials must be inversely designed from the viewpoints of the expected module structures and mass-production processes, especially for the purpose of energy harvesting. GRAPHICAL ABSTRACT
1 December 2008 in Applied Catalysis B: Environment and Energy