14 October 2025 in IEEE Internet of Things Journal
In a long-endurance underwater vehicle rotational inertial navigation system (RINS), the rotation strategy significantly impacts navigation accuracy. To address the limitations of the dual-axis 16-position rotation modulation scheme, specifically, its large rotation angles and inability to modulate errors arising from the coupling of scale factors and Earth’s rotation rate. This article proposes a geocentric frame-based tri-axial 32-position rotation modulation method. This method suppresses navigation errors by altering the direction of the rotation axis and increasing the rotation sequence. It simultaneously isolates the Earth’s rotation rate, thereby eliminating the coupling error between inertial sensor scale factors and Earth rotation, and enhancing system navigation accuracy. Experimental results demonstrate that the system achieves a navigation positioning accuracy of approximately 2.2 nautical miles (n mile) over 72h. Compared to a single-axis RINS, positioning accuracy is improved by a factor of 8. Compared to a dual-axis RINS, positioning accuracy is enhanced by 0.75 n mile. These results validate the effectiveness of the proposed method in improving navigation accuracy.
13 August 2024 in IEEE Transactions on Instrumentation and Measurement
In the initial alignment of the strapdown inertial navigation system, it is difficult to obtain sufficient data information to make the optimized state of convergence in a short time, which cannot realize fast alignment, and the accuracy of the alignment results is poor. The dynamic sliding window is difficult to recover after marginalization, and the linearization points of the Jacobi matrix are inconsistent, leading to the zero-space variation of the information matrix. To address the above problems, we propose an inertial alignment algorithm for sliding window reverse optimization delayed marginalization (RODM) to improve the rapidity and accuracy of the alignment algorithm. The method of storing gyro and accelerometer data during the alignment process and repeatedly solving the stored inertial data using forward and reverse navigation solving and optimization algorithms (OAMs) is used as a way to extend the interval of inertial data collected in a short period of time so that there is enough inertial data to enable the convergence of the state variables of the sliding-window optimization for a short period of time to achieve fast alignment. A delayed marginalization factor is used to update the marginalized prior information, solving the problem that the linearization of the Jacobi matrix must be fixed point to improve the accuracy of the alignment algorithm. We propose an algorithm to improve the accuracy of alignment, which we have verified the rapidity and accuracy of our initial alignment system in the turntable test, where the accuracy of the alignment heading angle reaches 0.136467 mil in 3 min, providing accurate attitude information for navigation and localization.
29 August 2024 in IEEE Sensors Journal
Aiming at the problem of weak initial alignment anti-interference ability of vehicle mounted single axis rotating inertial navigation system under complex conditions, which leads to poor alignment accuracy and navigation accuracy. In this paper, we combine the reverse navigation with the improved Sega-Husa filtering algorithm, and propose an initial alignment method based on reverse navigation Sega-Husa kalman filtering (RSKF). Firstly, coarse alignment is performed and key data are stored at the same time. After coarse alignment, the initial posture of coarse alignment and stored data are used for adaptive filtering alignment based on forward and reverse navigation. This method can fully mine and use the data. The experimental results show that compared to traditional algorithms, the method significantly augments the accuracy of alignment, and thereby elevating the navigation precision of the vehicle’s single-axis rotational inertial guidance system.
18 July 2024 in Measurement
1 January 2026 in IEEE Transactions on Instrumentation and Measurement
1 January 2026 in IEEE Transactions on Instrumentation and Measurement