12 April 2017 in IEEE Journal of Solid-State Circuits
A 65-nm CMOS, 18-mm2, 1.5-GHz 64 $\times $ 64 cross-correlator with 128 on-chip analog-to-digital converters (ADCs) enables real-time synthetic aperture radiometric imaging. This brief enables high-resolution synthetic aperture radiometry by greatly improving the integration and energy efficiency of the mixed-signal baseband cross-correlator. The design supports analog-in and digital correlation out, removing approximately 5 W of power that would otherwise be needed for I/O between the ADCs and the digital correlation core. The prototype 6.144T correlation/s 1.5 Gsamples/s 64 $\times $ 64 correlator is designed for satellite-based radiometric imaging of water in the atmosphere. Massive parallelism together with an optimized correlation scheme leads to a measured energy consumption of only 0.35 pJ/correlation/cycle. A correlation efficiency greater than 90% is achieved for input signal levels greater than −30 dBm.
6 June 2019 in IEEE Transactions on Microwave Theory and Techniques
A digital eight-element beamforming RF modulator allows accurate steering of multiple independent beams. The key to the efficiency is the pairing of area-efficient bandpass Δ Σ modulation with N-path filtering to suppress quantization noise. Beamforming digital signal processing (DSP) is enabled by careful frequency management, which facilitates efficient digital phase shifting, upsampling, and upconversion. A 40-nm CMOS prototype generates two 1.2-GHz beams, with 40-MHz RF bandwidth. The prototype consumes 128 mW and occupies an active area of only 0.19 mm², which is only 16 mW and 0.02 mm² per element. This represents an order-of-magnitude improvement in area and power consumption per element compared to the state-of-the-art digital to RF modulators.
24 August 2021 in IEEE Journal of Solid-State Circuits
Beamforming is an essential tool for speaker selection and rejection of environmental noise in automatic speech recognition. This work harnesses the efficiency of delay-and-sum (DAS) beamforming by combining it with constant-directivity beamforming (CDB) and frequency-domain feature extraction. CDB facilitates DAS by restricting the bandwidth for different microphone configurations. An array of sigma–delta modulators (SDMs) digitizes eight microphone inputs. The design takes advantage of bitstream processing of the modulator outputs for beamforming and extracting 60 Mel spectrum power features. The prototype device is fabricated in the 40-nm CMOS and occupies 1.1 mm2. Each SDM consumes 91 mW and has a measured signal-to-noise and distortion ratio of 84 dB for an 8-kHz bandwidth. The beamformer and feature extractor consume a dynamic power of 76 and 122 mW, respectively. The entire power consumption of the prototype is 3.95 mW, including leakage power. Processing the Mel spectrum outputs with a DNN, the keyword spotting accuracy in the presence of noise improves from 74% without beamforming to 93% with beamforming.
1 September 2019 in IEEE Solid-State Circuits Letters
This letter presents a new class of ΔΣ modulator that combines any set of traditional NTF shapes in a single modulator. The prototype multiband ΔΣ modulator (MB-ΔΣM) demonstrates two simultaneous bands - one baseband and one bandpass. These two bands are separated by 500 MHz, have an aggregate bandwidth of 90 MHz, with up to 55-dB measured SNDR. In addition to reducing the number of ADCs, this new approach promises further system-level power savings by simplifying the RF frontend. The system-level power savings from requiring fewer analog mixers, LNAs, filters, and ADC drivers can be even more than the ADC power reduction.