A nanoporous composite film combined of conducting inorganic template (TiO2/SnO2) and conducting polymer catalyst (poly(3,4-ethylenedioxythiophene):polystyrenesulfonate, PEDOT:PSS) was developed as an alternative counter electrode for dye-sensitized solar cell (DSSC) through lowtemperature process. The TiO2/SnO2 template was first fabricated by coating a homogeneous TiO2 nanoparticles blended paste containing a SnCl4 aqueous solution on the conductive substrate, followed by annealing at 150 °C. The counter electrode was then completed by spincoating the PEDOT:PSS aqueous solution into the template and drying at 80 °C. The obtained TiO2/SnO2/PEDOT:PSS (TSP) composite film exhibits more excellent catalytic activity for the triiodide reduction than the pristine PEDOT:PSS film, resulting in the significant improvements in the fill factor and efficiency of the cells. The values of the fill factor and efficiency respectively increase from 0.564 and 4.79% to 0.699 and 6.54%. Noted that the photovoltaic performances of the TSP based DSSC is very similar to those of the Pt based one. The fill factor and efficiency of the later are 0.696 and 6.48%, respectively. The outstanding properties of the TSP composite film used as the counter electrode can be ascribed to its prominent synergistic effects. In the TSP composite film, the conducting TiO2 is applied as the main skeleton material with the in-situ formed SnO2 as a binder to construct a nanoporous structure for the PEDOT:PSS coating and also to provide numerous high-speed conductive paths for the electron transportation from the substrate to the PEDOT:PSS coating, and the PEDOT:PSS adhered on the TiO2/SnO2 skeleton mainly acts as the catalyst to enlarge its surface area allowing for more active sites for the tri-iodide reduction.
Hexagonal boron nitride (HBN), which has the same crystal structure as graphite, has been used as catalytic material for a counter electrode in dye-sensitized solar cells (DSCs) to investigate its potential application. X-ray diffraction (XRD) has been used to confirm the crystal structure of HBN, scanning electron microscopy (SEM) has been used to characterize the morphology of HBN film on counter electrode, and electrochemical workstation has been employed to obtain the electrochemical impedance spectroscopy (EIS) and corresponding impedance parameters. Results show that the HBN film has rough surface and porous structure with pore size of less than 1 μm. When employed the HBN counter electrode to DSCs, the conversion efficiency (η) is only about a tenth of that of graphite based DSCs. Low efficiency of HBN based DSCs is induced by high charge transfer resistance (Rct) of HBN counter electrode, which means that HBN can hardly provide catalytic activity for the reduction of the triiodide ion. Therefore, the crystal structure is not a crucial factor to select the catalytic material for a counter electrode in DSCs. Moreover, the short circuit photocurrent density (Jsc) and the open circuit voltage (Voc) of device also evidently depend on the characteristics of catalytic material.