The electrothermal performance of laser-induced graphene (LIG)- based heater can be improved by increasing the laser power in a certain range. However, excessive laser power will cause the produced LIG film to detach from the substrate, resulting in the degradation of performance. In this letter, a novel strategy of repeated laser writing is proposed to further improve the electrothermal performance of LIG-based heater. The best optimized result appears after four- time repeated laser writing at a certain power. After the device is irradiated for four times, the best steady-state temperature increases by 103.8%, which is 43.8% higher than that of the heater fabricated by the method of only increasing the laser power while not repeated laser irradiation.
The development of two-dimensional materials with gas-sensitive properties has been a research focus in the field of materials science. Considering the excellent properties of graphene and hexagonal boron nitride, a monolayer composite is put forward and its potential for gas sensing has been investigated by density functional theory. Compared to common gases in the atmosphere and three other toxic gases, sulfur dioxide tends to have a strong mutual effect with this composite. Together with electronic analyses, it is proved that the composite presents excellent sensitivity toward sulfur dioxide molecules and the conductivity can be used as a vital parameter to diagnose the status of gas sensor. What’s more, a co-adsorption model demonstrates a favorable performance in high moisture working environment. Thus, we can reasonably draw the conclusion that the presented composite could be an eligible candidate for sulfur dioxide gas detection.
10 November 2020 in ACS Applied Materials & Interfaces