Urrently, environmental issues are a top priority, with water management being one of the most critical concerns. Another key aspect is improving energy production, which can be achieved through wastewater treatment using anaerobic digestion (AD), as the methane generated in this process can be utilized as an energy source while simultaneously treating the wastewater. Therefore, the objective of this thesis was to enhance methane production by employing pretreatment methods, specifically thermal pretreatment (TP) and the addition of metal nanoparticles (NPs), and to evaluate both their individual effects and their potential synergistic effect. The experimental work was structured in three stages: In the first stage, iron oxide NPs, with and without a support, were synthesized and characterized, using commercial alumina as the support material. Two sol-gel methods were employed to determine which one offered better energy efficiency. The resulting nanomaterials were characterized using various techniques, including scanning and transmission electron microscopy, infrared spectroscopy, X-ray diffraction, and temperature-programmed reduction analysis. In the second stage, wastewater was collected and characterized from a slaughterhouse, allowing for the determination of the parameters necessary for its application in methane potential tests. Finally, in the third stage, biomethane potential tests were performed, and the modified first and Gompartz models were applied to the cumulative methane production curves, along with an energy balance analysis. In the first experiment, the influence of thermal pretreatment (100°C, 1 atm, 30 min), the addition of supported and unsupported iron oxide NPs (120 mg/L), and the combination of both pretreatments were evaluated. The results indicated that TP did not enhance methane production due to the formation of recalcitrant compounds during the process. However, the supported NPs increased methane production by 27.78%. In the second experiment, the influence of supported and unsupported NPs was analyzed, varying their concentrations (30, 60, and 120 mg/L). The different concentrations showed similar methane production yields. For reasons of sustainability and efficient material use, the optimal condition was considered to be the use of supported nanoparticles at a concentration of 30 mg/L, which showed a 32.95% improvement. The experimental results demonstrated that the addition of nanoparticles improved the anaerobic digestion (AD) process, not only by increasing methane production, but also by enhancing key parameters such as specific methanogenic activity, organic matter removal, and the creation of reducing conditions, which are ideal for this type of system. The use of alumina-supported nanoparticles at a concentration of 30 mg/L was considered the ideal condition, as it allows achieving comparable results while using a smaller amount of metal material. The experimental results were satisfactorily fitted to the modified first-order and Gompertz models, yielding sigmoid curves characteristic of first-order kinetics. Finally, the energy balance revealed that the energy gain from enhanced methane production accounted for only 10% of the energy required for synthesizing the nanoparticles.