We report on ultra-wide bandgap (UWBG) Al0.7Ga0.3 N channel metal-oxide-semiconductor field-effect transistors (MOSFETs) grown by metal-organic chemical vapor deposition (MOCVD). Employing reverse Al composition graded ohmic contact layers and 20 nm Al2 O 3 gate-dielectric, 250 nm thick Al0.7Ga0.3 N:Si channel MOSFETs resulted in maximum current density of 0.5 A/mm, which is the highest value reported for AlGaN channels with Al composition > 0.25. Transistors with a gate-drain spacing (L GD) of 1.7 μm demonstrated a breakdown voltage (V DG) of ~620V, translating in an average lateral breakdown field of ~3.6 MV/cm. This work establishes UWBG AlGaN as a promising candidate for advanced RF applications.
In this letter, we discuss the application of low pressure chemical vapor deposition (LPCVD) grown SiNx passivation-first process to improve the power density and linearity performance of a metal oxide chemical vapor deposition (MOCVD) grown AlGaN channel polarization-graded field-effect transistor (PolFET). Significantly improved dispersion behavior was observed compared to plasma enhanced chemical vapor deposition (PECVD) grown SiNx passivation. The Current collapse at 30 V drain quiescent condition for pulsed I-V was reduced to 8% (LPCVD) from 25% (PECVD). 10 GHz load-pull measurement showed a maximum output power density of 3.4 W/mm with a peak power added efficiency (PAE) of 40%. Twotone intermodulation distortion measurement at 10 GHz for devices with 150..m width revealed an OIP3 of 39 dBm and an excellent corresponding linearity figure of merit OIP3/PDC of 13.3 dB. This is the best device level OIP3/PDC reported to date at Xband for III-Nitride microwave transistors.
We report on the power and linearity performance of metal organic chemical vapor deposition (MOCVD) grown AlGaN channel polarization-graded field-effect transistor (PolFET). The fabricated transistors with 3-dimensional electron channels showed nearly flat transconductance profiles. Maximum fT and fmax of 23 GHz and 65 GHz were measured for 0.7 μ m gate-length transistors, corresponding to an fT-LG product of 16.2 GHz-μm. Load-pull measurement at 10 GHz revealed a maximum output power of 2 W/mm with a maximum small signal gain of 16 dB. Two tone measurement at 10 GHz showed an OIP3 of 33 dBm for 150 μm device width, and a corresponding linearity figure of merit OIP3/PDC of 3.4 dB. These results suggest that PolFETs could be useful for high frequency applications requiring high linearity.
We report on the demonstration of high current density in Al 0.65 Ga 0.35 N/Al 0.4 Ga 0.6 N heterojunction field effect transistors with micro-channels enabled by enhanced contact injection. Devices with a gate length of 100 nm exhibited a maximum current density of 910 mA/mm and a maximum transconductance of 140 mS/mm. A current gain cut off frequency of 20 GHz and maximum oscillation frequency of 36 GHz were obtained. Large-signal load-pull characterization of the transistors showed output power density of 2.7 W/mm at 10 GHz. The current density and output power density represent the state-of-art performance for high Al-composition AlGaN channel transistors.