Abdelaziz Arroussi

Abdelaziz Arroussi

Auto-generated profile, based on publicly available information

Abdelaziz Arroussi

Laboratory of Saharan Natural Resources, Faculty of Natural and Life Sciences, University of Ahmed Draia, Adrar, Algeria

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 April 2025 in Fibers and Polymers
Verified
Journal Article
Closed access
PDF file
AAAbdelaziz Arroussi
Abdelaziz Arroussi
HLHamza Laksaci
Hamza Laksaci
MDMohammed Djaafri
Mohammed Djaafri
AHAbderrahmane Hiri
Abderrahmane Hiri
OKOmar Khelifi
Omar Khelifi
SKSlimane Kalloum
Slimane Kalloum

31 March 2025 in Comptes Rendus. Chimie
Verified
Journal Article
Open access
PDF file
AAAbdelaziz Arroussi
Abdelaziz Arroussi
HLHamza LAKSACI
Hamza LAKSACI
MDMohammed Djaafri
Mohammed Djaafri
ATAhmed Tahri
Ahmed Tahri
MDMohammed Amine Dahou
Mohammed Amine Dahou
Mejdi JeguirimMejdi Jeguirim
Mejdi Jeguirim
The pollution of water resources by hazardous contaminants is a major obstacle to the provision of safe and potable water worldwide. Cost-effective, innovative, renewable, and environmentally friendly technologies are essential for wastewater treatment. In the current work, the potential of using raw date palm petiole (DPP) for the removal of Bezaktiv Marine S-BL (SBL) dye is investigated under a wide range of experimental conditions in batch mode. Experimental results show that the removal of SBL dye by DPP is highly dependent on contact time, initial pH, initial dye concentration, and temperature. The removal of SBL dye is relatively rapid where the equilibrium state is reached within a contact time of 120 min. Moreover, the biosorbent exhibits high stability in SBL adsorption ability over a wide pH range (4–12). Furthermore, the SBL dye adsorption increases with increase in initial concentration. The maximum adsorption capacity of the SBL dye on DPP is evaluated to be 110 mg/g, which is much higher than numerous other materials. In addition, a thermodynamic study indicates that the adsorption of SBL dye by DPP is a feasible exothermic and spontaneous process. The findings of the present study indicate that untreated DPP wastes can be considered effective materials for the treatment of textile dyes in wastewater in general and SBL in particular.

2 February 2026 in Reaction Kinetics, Mechanisms and Catalysis
Verified
Journal Article
Closed access
PDF file
AAAbdelaziz Arroussi
Abdelaziz Arroussi
HLHamza Laksaci
Hamza Laksaci
AHAbderrahmane Hiri
Abderrahmane Hiri
HAHakim Aguedal
Hakim Aguedal
MSManal Sila
Manal Sila

24 September 2026 in Comptes Rendus. Chimie
Verified
Journal Article
Closed access
MSManal Sila
Manal Sila
AAAbdelaziz Arroussi
Abdelaziz Arroussi
HLHamza LAKSACI
Hamza LAKSACI
AHAbderrahmane Hiri
Abderrahmane Hiri
HAHakim Aguedal
Hakim Aguedal
Mejdi JeguirimMejdi Jeguirim
Mejdi Jeguirim
This research investigates the preparation of a zeolite X (Z-X), its deep characterization by using various analytical techniques, and its ability in adsorbing a typical dye malachite green (MG) from aqueous solutions under wide batch experimental conditions. The physicochemical characterization reveals that Z-X is a highly crystalline and pure faujasite-type material. It has a polyhedral morphology and a well-developed texture with an enhanced surface area (313.8 m 2 ·g –1 ). Adsorption tests show that MG removal from aqueous solutions is rapid and significantly increases with increasing the solution’s pH, the MG initial concentration, and the adsorbent dose. The highest MG removal capability is evaluated to be 166.7 mg·g –1 at a temperature of 10 °C and exceeds those of various engineered materials. Moreover, the MG removal is found to be spontaneous, exothermic, and mainly governed by physical mechanisms. The cost of adsorbent preparation and application for MG removal and Z-X regeneration is evaluated to be 9.24 USD·kg –1 , which represents an attractive price in comparison with various available synthetic adsorbents. All these results show that Z-X can be considered a cost-effective material for the removal of dyes from industrial effluents.