16 September 2008 in IEEE Journal of Solid-State Circuits
We present the design and measurement results of millimeter-wave integrated circuits implemented in 65-nm baseline CMOS. Both active and passive test structures were measured. In addition, we present the design of an on-chip spiral balun and the transition from CPW to the balun and report transistor noise parameter measurement results at V-band. Finally, the design and measurement results of two amplifiers and a balanced resistive mixer are presented. The 40-GHz amplifier exhibits 14.3 dB of gain and the 1-dB output compression point is at +6-dBm power level using a 1.2 V supply with a compact chip area of 0.286 mm2. The 60-GHz amplifier achieves a measured noise figure of 5.6 dB at 60 GHz. The AM/AM and AM/PM results show a saturated output power of +7 dBm using a 1.2 V supply. In downconversion, the balanced resistive mixer achieves 12.5 dB of conversion loss and +5 dBm of 1-dB input compression point. In upconversion, the measured conversion loss was 13.5 dB with -19 dBm of 1-dB output compression point.
14 December 2017 in IEEE Transactions on Microwave Theory and Techniques
This paper validates a design and modeling methodology of coupled slow-wave waveguides (CS-CPW) by presenting a D-band CMOS low-noise amplifier (LNA) that utilizes the CS-CPW for impedance matching. The robustness and feasibility of using the CS-CPW as a matching element in wideband millimeter-wave (mm-wave) silicon circuit designs are studied. Furthermore, the key design details of a mm-wave LNA are discussed. The designed monolithic microwave integrated circuit amplifier has a gain greater than 10 dB from 135 to 170 GHz with a peak gain of 15.7 dB at 160 GHz. The amplifier has a measured noise figure of 8.5 dB from 135 to 170 GHz, and an output-referred 1-dB compression point of -16.5 dBm at 160 GHz. The total power consumption of the amplifier is 32 mW.
30 January 2017 in IEEE Transactions on Microwave Theory and Techniques
Recent advancements in transistor technology, such as the 35 nm InP HEMT, allow for the development of monolithic microwave integrated circuit (MMIC) low noise amplifiers (LNAs) with performance properties that challenge the hegemony of SIS mixers as leading radio astronomy detectors at frequencies as high as 116 GHz. In particular, for the Atacama Large Millimeter and Submillimeter Array (ALMA), this technical advancement allows the combination of two previously defined bands, 2 (67-90 GHz) and 3 (84-116 GHz), into a single ultra-broadband 2+3 (67-116 GHz) receiver. With this purpose, we present the design, implementation, and characterization of LNAs suitable for operation in this new ALMA band 2+3, and also a different set of LNAs for ALMA band 2. The best LNAs reported here show a noise temperature less than 250 K from 72 to 104 GHz at room temperature, and less than 28 K from 70 to 110 GHz at cryogenic ambient temperature of 20 K. To the best knowledge of the authors, this is the lowest wideband noise ever published in the 70-110 GHz frequency range, typically designated as W-band.
18 April 2005 in IEEE Transactions on Microwave Theory and Techniques
We report two resistive mixers, i.e., a balanced and a balanced image-rejection (IR) mixer for the 60-GHz frequency range. A compact and wide-band method for the local-oscillator (LO) power division is presented. The 56-GHz LO signal, which propagates in a coplanar-waveguide mode, is divided in between the lines of two spiral baluns. Consequently, a smooth and compact transition from even-to-odd propagation mode and an in-phase power division for two singly balanced unit mixers is achieved. As a result, the developed IR mixer occupies only 1.41mm/sup 2/ of chip area. The balanced design achieved 11.5 dB of conversion loss from 57 to 67 GHz with a fixed IF of 5.3 GHz. The corresponding LO suppression was better than 34 dB with 8 dBm of LO power. The IR mixer achieved better than 19 dB of IR ratio and better than 36 dB of LO suppression for an RF frequency from 57 to 66 GHz. The corresponding conversion loss varies from 13 to 16 dB. The measured 1-dB compression point of the IR mixer was at a -13-dBm output power level and the third-order intercept point was at a 4-dBm level.
11 February 2016 in IEEE Transactions on Microwave Theory and Techniques
In this paper we discuss the design of low-noise amplifiers (LNAs) for both cryogenic and room-temperature operation in general and take the stability and linearity of the amplifiers into special consideration. Oscillations that can occur within a multi-finger transistor are studied and verified with simulations and measurements. To overcome the stability problem related to the multi-finger transistor design approach a parallel two-finger unit transistor monolithic microwave integrated circuit LNA design technique, which enables the design of wideband and high-linearity LNAs with very stable, predictable, and repeatable operation, is proposed. The feasibility of the proposed design technique is proved by demonstrating a three-stage LNA packaged in a WR10 waveguide housing and fabricated using a 35-nm InP HEMT technology that achieves more than a 20-dB gain from 75 to 116 GHz and 26-33-K noise temperature from 85 to 116 GHz when cryogenically cooled to 27 K.