1 February 2014 in Journal of Power Sources
KTK. Ravindranathan Thampi
1 January 2015 in Solar Energy Materials and Solar Cells
7 February 2014 in Green Chemistry
Novel solvent free task specific ionic liquid (TSIL) electrolytes for dye sensitised solar cells (DSSC) were synthesised and tested. Of great concern is the replacement of low-moderate toxicity second generation ILs, with high toxicity third generation TSILs. As most 1-butyl-3-methylimidazolium (Bmim) and especially 1-ethyl-3-methylimidazolium (Emim) based ILs have low toxicity, the designing of replacement TSILs of comparable toxicity is a challenge. Structural features of TSIL investigated herein were incorporation of heteroatoms into the side chain of imidazolium cations (i.e. ether, ester and amide) and anion (bromide, iodide, and triflimide [NTf2]). Preliminary toxicity screening against 20 microorganisms (8 bacteria and 12 fungi) found that all ILs, imidazolium salts, N-butylbenzimidazole (NBB) and guanidinium thiocyanate (GNCS) do not exhibit high antimicrobial toxicity. However NBB and a pentyl ester substituted IL displayed moderate toxicity to several strains of bacteria and fungi. Further toxicity testing to establish IC50 values shows several novel TSIL compounds and imidazolium salts are in fact less toxic to microorganisms (e.g. bacteria) than commonly used 1-ethyl-3-methylimidazolium iodide (EmimI) and 1,3-dimethylimidazolium iodide (DmimI). We have demonstrated that the presence of ether and either ester or amide groups in the structure of the cation of the TSIL and imidazolium salts reduces antimicrobial toxicity, which is consistent with the lowering of the lipophilicity of ILs. Iodide and bromide analogues have lower toxicity than the NTf2 examples in this study. The DSSC performance using these “greener” ILs in place of the standard EmimI compare quite favourably. Two low antibacterial toxicity iodide examples exhibit photocurrents of 9.27 mA cm−2 and 8.85 mA cm−2, respectively, achieving promising efficiencies of 3.39% and 3.31%, respectively (EmimI = 4.94%). DSSC performance is further improved by 15% minimum to 66% maximum, depending on IL chosen, by the presence of small amounts of moisture and DSSCs employing a low antibacterial toxicity iodide TSIL or imidazolium salt can surpass the performance of dry EmimI. Of note the DSSC containing TSIL NTf2 examples, performed poorly compared to the halide analogues, with the outcome that the most toxic TSILs under investigation are also the least preferred based on performance.
12 December 2013 in Progress in Photovoltaics: Research and Applications
1 December 2014 in Solar Energy
In this study, we report improved power conversion efficiencies of various carbon based quasi-solid state electrolytes/DSSCs by optimising the thickness of TiO2 layer, incorporation of TiO2 scattering layer and application of dense compact surface layers of TiO2 on working electrodes. Single wall carbon nanotube (SWCNT) based quasi-solid state electrolytes showed increased power conversion efficiencies from 1.43% to 3.49%. For the mixture of graphene and SWCNTs the power conversion efficiencies improved from 2.50% to 2.93%. However, graphene based quasi-solid state electrolytes displayed small decreases in power conversion efficiencies from 2.10% to 1.96% due to the more viscous nature of this electrolyte. Electrochemical Impedance Spectroscopy (EIS) demonstrated that the addition of these various carbon based nanomaterials into PMII significantly decreases the charge transfer resistance at the counter electrode and hence the much better performance obtained with carbon based quasi-solid state electrolytes compared to pure PMII based DSSCs
27 April 2010 in The Journal of Chemical Physics
Narrow linewidth emission features observed in the near-UV following y P6 state excitation of atomic manganese isolated in the solid rare gases are assigned to b D4 and a P4 states. These states arise from the 3d54s2 electronic configuration, identical to that of the S6 ground state, and the origin of the narrow linewidths. Two thermally stable sites, labeled blue and red on the basis of their position in absorption spectra, are occupied by atomic Mn in Ar and Kr while a single site is present in Xe. The red site produces a single, narrow line emission for the b D4 state at 329 nm. In contrast, a lineshape analysis of the complex blue site b D4 state emission between 331 and 332 nm reveals the occurrence of three zero phonon lines (ZPLs). Millisecond emission decay curves recorded for these features are found to be complex, requiring double and triple exponential fit functions. The origins of the complex decays and multiple ZPLs are shown to arise from weak crystal field splitting (CFS) of the J=7/2 spin-orbit level of the b D4 state of atomic Mn isolated in the blue site of the solid rare gases. Fields of cubic symmetry are capable of inducing splitting for J>3/2 so atoms isolated in both single vacancy and tetravacancy sites in the fcc lattices of the solid rare gases are prone to this effect. b D4 state emission is also produced following y P6 excitation for Mn atoms occupying the red sites in Ar and Kr. However, Mn atoms isolated in the larger tetravacancy sites have small matrix shifts and do not exhibit any CFS. The magnitudes of the weak CF splittings are shown to depend on both the excited state electronic configurations 3d54s2 b D4 and 3d64s1 a D4 states and the size of the matrix site occupied by atomic Mn.