4 May 2020 in Journal of Fluid Mechanics
A multi-scale Euler–Lagrange method was developed and applied to numerically assess cavitation-induced erosion based on the collapse dynamics of Lagrangian bubbles. This approach linked macroscopic and microscopic scales and captured large vapour volumes on an Eulerian frame, while small vapour volumes were treated as spherical Lagrangian bubbles. Interactions between vapour bubbles and the liquid phase were considered via a two-way coupling scheme. A verification and sensitivity study of the developed procedure to transform vapour volumes between Eulerian and Lagrangian frames was performed. First, the developed method was validated for bubble dynamics, using analytical and experimental data. Second, the cavitating flow through an axisymmetric nozzle was simulated using a measurement-based distribution of cavitation nuclei. Details of single bubble collapses were used to assess cavitation erosion. Based on well-recognised fundamental experiments and theoretical considerations from the literature, model assumptions were derived to account for the effects of a bubble’s stand-off distance on the bubble’s motion and its radiated pressure during an asymmetric near-wall bubble collapse. Computed maximum collapse radii of bubbles correlated well with diameters of measured erosion pits. Considering a nonlinear dependence of erosion on impact pressure, calculated erosion potentials compared well to measured erosion depths.
1 September 2019 in Marine Structures
3 December 2015 in Journal of Physics: Conference Series
The present work aims to predict cavitation erosion using a numerical flow solver together with a new developed erosion model. The erosion model is based on the hypothesis that collapses of single cavitation bubbles near solid boundaries form high velocity microjets, which cause sonic impacts with high pressure amplitudes damaging the surface. The erosion model uses information from a numerical Euler-Euler flow simulation to predict erosion sensitive areas and assess the erosion aggressiveness of the flow. The obtained numerical results were compared to experimental results from tests of an axisymmetric nozzle.
6 October 2025 in Journal of Fluid Mechanics
We developed a numerical method to investigate the effects of flow properties and phase transition between a gas and a liquid on sloshing-induced impact pressures acting on the walls of a partially filled tank. The conservation equations of mass, momentum and energy, as well as a transport equation for the volume fraction, were solved by considering flow compressibility, surface tension and phase transition. We modelled the phase transition by employing a mass transfer model, and validated our numerical method against experimental data. We investigated the effects of flow compressibility and density ratio between gas and liquid, representing a range similar to that of natural gas and hydrogen. We examined the effects of phase transition on sloshing-induced impact loads caused by a single-impact wave with gas pockets. Compressibility, density ratio and phase transition significantly affected the flow of the liquid–gas interface in the tank and, consequently, the impact pressure. The gas compressibility, caused by a single-wave impact with gas pockets, reduced the impact pressures significantly. Although the influence of density ratio on impact pressures is often emphasised, we demonstrated that, for impacts with gas pockets, the gas density was decisive and not the density ratio. With increasing gas density, the shape of the liquid–gas interface changed, and the pressure peak decreased. For the cases investigated, the viscosity of the liquid phase hardly influenced the impact pressures. Furthermore, the phase change during condensation considerably reduced the impact pressure peak. The pressure fluctuations after the first impact were strongly damped due to the vaporisation process.