Optical characterizations of preferred orientation (002) ZnO thin films, prepared by RF magnetron sputtering under pure argon plasma, with different thicknesses have been investigated, where grain size and resistivity increase with thickness. Energy band gap and refractive indices have been calculated. A correlation between band gap values and crystalline quality, which is improved with thickness, has been discussed. The calculated refractive indices of the thicker deposited films have increased as the thickness increases. Full width Half Maxima (FWHM) of band gap Photoluminescence (PL) emission decreases with thickness increasement due to quality improvement as it has been monitored by X-Ray Diffraction (XRD). A comparison between PL spectra of 1200 nm film and ZnO single crystal at low temperature is found to be similar.
Zinc Oxide thin films at room temperature with good crystallinity quality have been deposited at different Radio Frequency powers. Magnetron sputtering technique has been carried out on glass and oriented Si(100) substrates. The film structure has been characterized by X-ray Diffraction (XRD) and MicroRaman spectroscopy, which possesses a wurtzite structure with (002) preferential orientation selecting suitable conditions. Scanning electron microscope (SEM) and atomic force microscopy (AFM) have been utilized to determine the films surface morphology. The stoichiometry has been verified by Energy dispersive X-ray spectroscopy (EDX) analysis. The optical behaviors of the deposited films have been characterized by Ultraviolet Visible (UV-Vis) (optical transmittance measurements) as well as by Photoluminance characterization. Electrical properties, Current-Voltage (I-V) and Capacitance-Voltage (C-V) have been studied in details for Zinc Oxide on Silicon film that deposited at different Radio Frequency power. The high transparency, electrical behavior and smooth surface allow to use these Zinc Oxide films in photovoltaic cells and optoelectronics application.
Lead sulfide thin films were prepared by chemical bath deposition (CBD) on both glass and Si (100) substrates. XRD analysis of the PbS film deposited at 25°C showed that the prepared films have a polycrystalline structure with (200) preferential orientation. Larger grains could be obtained by increasing the deposition time. The prepared films were also chemically characterized using X-ray photoelectron spectroscopy (XPS), which confirmed the presence of lead and sulfur as PbS. While energy dispersive X-ray spectroscopy (EDX) technique was used to verify the stoichiometry of the prepared films. Atomic force microscopy (AFM) was used to study the change in the films’ morphology with the deposition time. The effect of the deposition time, on both optical transmittance in the UV-Vis-NIR region and the structure of the film, was studied. The obtained results demonstrated that the optical band gap decreased when the thickness increased.
1 August 2016 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms