Meniscus-confined electrodeposition (MCED) is an effective and versatile technique for fabrication of alloy structures with precise localization and high controllability. Here, the fabrication of cobalt-copper (Co/Cu) alloy microwires using MCED techniques is reported. Co/Cu microwires with a wide range of compositions (Co9Cu91 to Co100Cu0) and controllable morphology were printed using the co-electrodeposition mode from a single electrolyte. We utilized multiphysics finite element simulation to investigate the influence of electrolyte evaporation and electric field on the concentration distribution of metal ions in the meniscus. The concentration of ions at the substrate interface increases linearly with decreasing humidity and increasing current density, which can be used to fine turn the alloy composition. By further analyzing the alloy composition, we found that the electrodeposition of Cu is diffusion controlled, while Co is mainly electrochemical reaction controlled, as a results of combined action of surface evaporation and reaction dynamics in the meniscus. The prepared alloy wires are polycrystalline, dense and uniform composition distribution. The coercivity and magnetic anisotropy are enhanced by increasing of the copper content in the alloy wires. The high tunability of composition make this alloy a promising material for magnetic micro/nano-electromechanical devices.
Kirigami mechanical metamaterials provide exceptional tunability in mechanical properties and morphing capabilities, exhibiting great potential for deployable and actuatable devices. However, most kirigami structures can only deform freely within a 2D plane, with limited out‐of‐plane deformability, making them inadequate for constructing periodic objects with arbitrary 3D shapes. Here, a novel class of 3D mechanical metamaterials with hyperbolic kirigami tessellations has been developed. By projecting hyperbolic kirigami templates onto three types of triply periodic minimal surfaces, candidate structures are developed with remarkable properties. An extreme negative Poisson's ratio of ‐1 and tunable mechanical multistability are uncovered through theoretical analysis, numerical simulations, and experiments thanks to the flexible kirigami geometry. Notably, the structure achieves a maximum volume expansion of up to 488% during auxetic morphing. Furthermore, programmable morphing behaviors are demonstrated through voxelated assemblies of kirigami unit cells with varying geometrical parameters. The novel design strategy presented in this work based on hyperbolic kirigami tessellations opens up new avenues toward auxetic and multistable mechanical metamaterials with broad applications spanning shape‐morphing architectures, deployable space structures, and soft machines.
Complex three-dimensional copper (Cu) wires have been successfully fabricated by meniscus-confined electrodeposition (MCED) controlled by quasi-static stability of the meniscus. Here, we report a new dynamic meniscus stability based MCED process. The obtained copper microwires are straight, uniform in width and have a smooth surface (surface finish of 8.79 nm (Ra)). When current density higher than 31.81 mA/cm2, dense Cu microstructure is deposited on the cathode substrate, while current density between 12.13 mA/cm2 and 31.81 mA/cm2, sparsity structure was observed on the surface of the copper wire. This work provides a direct method to fabricate Cu microwires on conductive substrates without the use of additives.