11 March 2022 in Nature Communications
The narrow bandgap of near-infrared (NIR) polymers is a major barrier to improving the performance of NIR phototransistors. The existing technique for overcoming this barrier is to construct a bilayer device (channel layer/bulk heterojunction (BHJ) layer). However, acceptor phases of the BHJ dissolve into the channel layer and are randomly distributed by the spin-coating method, resulting in turn-on voltages (Vo) and off-state dark currents remaining at a high level. In this work, a diffusion interface layer is formed between the channel layer and BHJ layer after treating the film transfer method (FTM)-based NIR phototransistors with solvent vapor annealing (SVA). The newly formed diffusion interface layer makes it possible to control the acceptor phase distribution. The performance of the FTM-based device improves after SVA.Vodecreases from 26 V to zero, and the dark currents decrease by one order of magnitude. The photosensitivity (Iph/Idark) increases from 22 to 1.7 × 107.
1 November 2020 in Organic Electronics
31 July 2020 in Journal of Materials Chemistry C
The acceptor phase, which affects the free carrier transport by trapping the photogenerated minority carrier in the active layer, plays an important role in organic phototransistors (OPTs) based on a bulk heterojunction (BHJ). In this work, the FBT-Th4(1,4):PC61BM blend film with high mobility is selected as the active layer to construct the OPT. A model of the action of minority carrier movement on hole transmission is established by using the change rule of device performance under different donor/acceptor ratios. This model is tested and validated using PTB7:PC61BM-based OPT with low mobility. The results show that a continuous transmission channel of photogenerated minority carrier tends to form in the OPT under high concentration doping, which increases the probability that a minority carrier would recombine with the holes, leading to poor device performance. These results can provide practical guidance for the preparation of high-performance OPT devices. The optimized FBT-Th4(1,4) : PC61BM device with a low D/A ratio (∼10 : 1) obtained shows ultrahigh photoelectric detection performance (gain = 4.7 × 105, D* = 1.4 × 1016 Jones).
20 October 2023 in ACS Applied Materials & Interfaces
14 March 2024 in Journal of Materials Chemistry C
The narrow bandgap of a near-infrared (NIR) polymer and the large electrode spacing of a lateral structure are the main factors causing the high dark current of the NIR lateral polymer photodetector (L-PPD). In this work, a large potential barrier is formed by innovatively introducing higher-LUMO-level acceptors (TPBi) into the bulk heterojunction layer (PDPP3T:PC61BM), which ensures that the electrons recombine with holes instead of exhibiting transmission. Based on this phenomenon, a new strategy is proposed to decrease the dark current. Simultaneously, the large built-in electric field induced by polystyrene (PS) doping is utilized to compensate for the photocurrent loss caused by TPBi doping. Compared with a PDPP3T : PS : PC61BM L-PPD (1 : 1 : 3), a TPBi : PDPP3T : PS : PC61BM (1 : 2 : 2 : 6) device exhibited significant performance improvements. The dark current (1.3 × 10−11 A@V = −20 V) decreased by approximately 3 orders of magnitude, the Iph/Idark value (∼ 1.7 × 104@405 nm, ∼ 1.4 × 103@850 nm) increased by a factor of 1000-fold, and the response speed (5.3/1.8 ms) improved by nearly fivefold.
1 February 2022 in Journal of Materiomics