Truong Vo

Dr. Truong Vo

orcid

Research Focus & Metrics

Representative Publications

View All Publications
11 November 2015 in Physical Review E
Verified
Journal Article
Closed access
PDF file
TVTruong Quoc Vo
Truong Quoc Vo
MBMurat Barisik
Murat Barisik
Bohung KimBohung Kim
Bohung Kim
In this paper, we present an approach for predicting nanoscale capillary imbibitions using the Lucas-Washburn (LW) theory. Molecular dynamics (MD) simulations were employed to investigate the effects of surface forces on the viscosity of liquid water. This provides an update to the modified LW equation that considered only a nanoscale slip length. An initial water nanodroplet study was performed to properly elucidate the wetting behavior of copper and gold surfaces. Intermolecular interaction strengths between water and corresponding solid surfaces were determined by matching the contact angle values obtained by experimental measurements. The migration of liquid water into copper and gold capillaries was measured by MD simulations and was found to differ from the modified LW equation. We found that the liquid layering in the vicinity of the solid surface induces a higher density and viscosity, leading to a slower MD uptake of fluid into the capillaries than was theoretically predicted. The near-surface viscosity for the nanoscale-confined water was defined and calculated for the thin film of water that was sheared between the two solid surfaces, as the ratio of water shear stress to the applied shear rate. Considering the effects of both the interface viscosity and slip length of the fluid, we successfully predicted the MD-measured fluid rise in the nanotubes.

21 September 2016 in Scientific Reports
Verified
Journal Article
Open access
PDF file
TVTruong Quoc Vo
Truong Quoc Vo
Bohung KimBohung Kim
Bohung Kim
In molecular-level fluidic transport, where the discrete characteristics of a molecular system are not negligible (in contrast to a continuum description), the response of the molecular water system might still be similar to the continuum description if the time and ensemble averages satisfy the ergodic hypothesis and the scale of the average is enough to recover the classical thermodynamic properties. However, even in such cases, the continuum description breaks down on the material interfaces. In short, molecular-level liquid flows exhibit substantially different physics from classical fluid transport theories because of (i) the interface/surface force field, (ii) thermal/velocity slip, (iii) the discreteness of fluid molecules at the interface and (iv) local viscosity. Therefore, in this study, we present the result of our investigations using molecular dynamics (MD) simulations with continuum-based energy equations and check the validity and limitations of the continuum hypothesis. Our study shows that when the continuum description is subjected to the proper treatment of the interface effects via modified boundary conditions, the so-called continuum-based modified-analytical solutions, they can adequately predict nanoscale fluid transport phenomena. The findings in this work have broad effects in overcoming current limitations in modeling/predicting the fluid behaviors of molecular fluidic devices.

24 June 2015 in International Journal of Precision Engineering and Manufacturing
Verified
Journal Article
Closed access
PDF file
TVTruong Quoc Vo
Truong Quoc Vo
Bohung KimBohung Kim
Bohung Kim

8 February 2019 in RSC Advances
Verified
Journal Article
Open access
PDF file
MHMohammad Rashedul Hasan
Mohammad Rashedul Hasan
TVTruong Quoc Vo
Truong Quoc Vo
Bohung KimBohung Kim
Bohung Kim
Heat transfer across an interface between a monolayer coated solid substrate and fluid has been extensively analyzed through a series of non-equilibrium molecular dynamics simulations. The effect of the monolayer was studied by varying its atomic mass (mM) and interaction energy between monolayer particles (εMM). Even though the fluid adsorption plays a role in heat transfer at the solid–fluid interface, we found that the interfacial thermal resistance (Kapitza resistance) is highly affected by the insertion of monolayer without any further change in the liquid structure near the solid surface. The Kapitza length monotonically increases with the increase of mM irrespective of εMM. The observations were explained by analysis of the overlap of the phonon spectrum at the interface using vibrational density of states. The effect of the monolayer on the Kapitza length was summarized by a fourth polynomial function that demonstrates the contribution of both mM and εMM with respect to each other on the Kapitza resistance within the parametric range studied.

12 July 2017 in International Journal of Precision Engineering and Manufacturing-Green Technology
Verified
Journal Article
Closed access
PDF file
TVTruong Quoc Vo
Truong Quoc Vo
Bohung KimBohung Kim
Bohung Kim

1 October 2020 in Computational Materials Science
Verified
Journal Article
Closed access
TVTruong Vo
Truong Vo
BHBang He
Bang He
MBMichael Blum
Michael Blum
ADAngelo Damone
Angelo Damone
PNPania Newell
Pania Newell