In-situtransmission electron microscopy (in-situTEM) was performed to investigate the switching operation of a resistive random access memory (ReRAM) made of copper, tungsten oxide and titanium nitride (Cu/WOx/TiN). In the firstSet(Forming) operation to initialize the device, precipitation appeared inside the WOxlayer. It was presumed that a Cu conducting filament was formed, lowering the resistance (on-state). TheResetoperation induced a higher resistance (the off-state). No change in the microstructure was identified in the TEM images. Only when an additionalResetcurrent was applied after switching to the off-state could erasure of the filament be seen (over-Reset). Therefore, it was concluded that structural change relating to the resistance switch was localized in a very small area around the filament. With repeated switching operations and increasing operational current, the WOx/electrode interfaces became indistinct. At the same time, the resistance of the off-state gradually decreased. This is thought to be caused by Cu condensation at the interfaces because of leakage current through the area other than through the filament. This will lead to device degradation through mechanisms such as endurance failure. This is the first accelerated aging test of ReRAM achieved usingin-situTEM.
Ferroelectric resistive switching was artificially induced in a conductive ferroelectric capacitor by inserting a thin dielectric layer at an electrode/ferroelectric interface. Ferroelectric capacitors consisting of semiconducting Bi-deficient Bi1−δFeO3 layers with SrRuO3 electrodes showed no resistive switching, but resistive switching emerged in these ferroelectric capacitors when a thin LaFeO3 dielectric layer was inserted at one of the SrRuO3/Bi1−δFeO3 interfaces. In addition to resistive switching, SrRuO3/LaFeO3/Bi1−δFeO3/SrRuO3 devices showed rectifying current–voltage characteristics, suggesting an asymmetric potential distribution along the stacking direction in the device. The results shed light upon the mechanism of resistive switching in ferroelectric diodes and demonstrate that interface engineering provides a simple but effective approach toward controlling the ferroelectric resistive switching characteristics.