21 April 2009 in Journal of Physical and Chemical Reference Data
The International Association for the Properties of Water and Steam (IAPWS) encouraged an extensive research effort to update the IAPS Formulation 1985 for the Viscosity of Ordinary Water Substance, leading to the adoption of a Release on the IAPWS Formulation 2008 for the Viscosity of Ordinary Water Substance. This manuscript describes the development and evaluation of the 2008 formulation, which provides a correlating equation for the viscosity of water for fluid states up to and with uncertainties from less than 1% to 7% depending on the state point. This manuscript describes the development and evaluation of the IAPWS Formulation 2008 for the Viscosity of Ordinary Water Substance, which provides a correlating equation for the viscosity of water for fluid states up to and with uncertainties from less than 1% to 7% depending on the state point.
23 August 2012 in Journal of Physical and Chemical Reference Data
The International Association for the Properties of Water and Steam (IAPWS) encouraged an extensive research effort to update the IAPS Formulation 1985 for the Thermal Conductivity of Ordinary Water Substance, leading to the adoption of a Release on the IAPWS Formulation 2011 for the Thermal Conductivity of Ordinary Water Substance. This paper describes the development and evaluation of the 2011 formulation, which provides a correlating equation for the thermal conductivity of water for fluid states from the melting temperature up to 1173 K and 1000 MPa with uncertainties from less than 1% to 6%, depending on the state point.
24 May 2003 in Industrial & Engineering Chemistry Research
1 February 2013 in International Journal of Thermophysics
26 July 2011 in Journal of Physical and Chemical Reference Data
This paper contains new, representative equations for the thermal conductivity of normal and parahydrogen. The equations are based in part upon a body of experimental data that has been critically assessed for internal consistency and for agreement with theory whenever possible. Although there are sufficient data at normal temperatures, data at very low or very high temperatures as well as near the critical region are scarce. In the case of the dilute-gas thermal conductivity, a new theoretically based correlation was adopted, as it agreed very well with the existing data. Moreover, in the critical region, the experimentally observed enhancement of the thermal conductivity is well represented by theoretically based equations containing just one adjustable parameter. The correlations are applicable for the temperature range from the triple point to 1000 K and pressures up to 100 MPa for both normal hydrogen and parahydrogen.
1 March 2000 in Journal of Research of the National Institute of Standards and Technology
A transient hot-wire apparatus was used to measure the thermal conductivity of argon with both steady-state and transient methods. The effects of wire diameter, eccentricity of the wire in the cavity, axial conduction, and natural convection were accounted for in the analysis of the steady-state measurements. Based on measurements on argon, the relative uncertainty at the 95 % level of confidence of the new steady-state measurements is 2 % at low densities. Using the same hot wires, the relative uncertainty of the transient measurements is 1 % at the 95 % level of confidence. This is the first report of thermal conductivity measurements made by two different methods in the same apparatus. The steady-state method is shown to complement normal transient measurements at low densities, particularly for fluids where the thermophysical properties at low densities are not known with high accuracy.