27 July 2023 in Journal of Vacuum Science & Technology A
The fabrication process of modern microelectronic devices faces a significant challenge regarding the uniformity of wafer processing during plasma etching. Particularly, nonuniformity is prominent at the wafer edge due to varying electrical properties, leading to sheath bending and distorted ion trajectories. To address this issue, a wafer terminating structure known as a focus ring is employed to modify the sheath structure near the edge of the wafer and ensure uniform ion fluxes. However, the focus ring is subject to erosion caused by the plasma, making it crucial to minimize the ion energy bombarding the focus ring. In light of this, this paper investigates the impact of parameters such as the wafer-focus ring gap, focus ring height, and dielectric constant of the focus ring on the ion angle onto the wafer and the ion energy onto the focus ring. To conduct the analysis, a 2D3V particle-in-cell/Monte Carlo collision model is utilized. The study reveals the existence of horizontal electric fields with opposite directions at the wafer edge and the inner edge of the focus ring. Optimizing the ion angle onto the wafer edge can be achieved by adjusting the material and geometry of the focus ring. Furthermore, reducing the ion energy at the focus ring can be accomplished by increasing the height or decreasing the dielectric constant of the focus ring.
1 May 2026 in Journal of Applied Physics
The plasma characteristics and nonlocal electron dynamics at 27.12 and 40.68 MHz in miniature inductively coupled argon plasmas are investigated using a two-dimensional implicit particle-in-cell/Monte Carlo collision model. At a very low pressure, energetic electrons from the skin layer interact nonlocally with the inductive electric field, resulting in alternating positive and negative power absorption regions at all driving frequencies. These energetic electrons gain energy in positive and lose energy in negative power absorption regions, forming anomalous current density peaks (i.e., current layers) at the interfaces between these regions. Increasing the chamber height and driving frequency are both found to promote the development of multiple current layers. Since the inductive electric field distribution is a superposition of the coil-induced field and the plasma current-induced field, current layers with high current density can significantly modulate the field. Particularly at a chamber height of 6 cm and a driving frequency of 40.68 MHz, the plasma current can induce an anomalous phase reversal of the local inductive electric field and locally disrupt the typical alternating pattern of positive-negative power absorption (manifested as two consecutive positive power peaks in space), which thereby induces positive power absorption over a broad spatial range. These findings provide critical insights into the low-pressure nonlocal electron dynamics, offering valuable guidance for optimizing plasma sources in applications.
1 May 2025 in Review of Scientific Instruments
This paper provides a comparative analysis of signal amplification principles between series and parallel radio frequency (RF) magnetic probes, underscoring the superior performance of the parallel configuration in measuring time-varying magnetic fields within RF plasma environments. To address inherent limitations of conventional parallel RF probes, particularly electrical asymmetry in compensation capacitors, an enhanced design incorporating a fully symmetric variable capacitor is proposed. Experimental results demonstrate that the upgraded probe amplifies differential mode (DM) signals from less than 300 mV to 1.2 V at 13.56 MHz while suppressing common mode (CM) signals below 700 μV. The fully symmetric variable capacitor design not only resolves thermal hazards from high-current conditions in series LC circuits but also enhances the probe's signal amplification capability across a broadband range, while achieving significant CM signal suppression through its symmetric architecture.